Thermador Dishwasher Model DW44Z | www.thermador.com |
Adding Rinse Agent
Rinse Agent
Rinse agent or a rinse aid is used to provide optimum drying results and diminish water spotting. Always use a rinse agent with the Thermador dishwasher to insure proper drying results. It rinses the dishware and also rinses the internal parts of the dishwasher.
To Fill the Rinse Agent Reservoir:
1.Open the dishwasher door fully.
2.Open the cover of the rinse agent dispenser by pressing the star on the cover with your index finger while pulling on the tab with your thumb.
3.Add rinse agent to the reservoir until the level indicator turns dark, indicating that the reservoir is full (capacity is approx. 3.5 oz.).
Rinse Agent Dispenser Regulator
The rinse agent reservoir of theThermador dishwasher is provided with a regulator calibrated from 1 to 6. (See Figure 15.) This regulator controls the amount of rinse agent dispensed. The dishwasher leaves the factory preset to 4. However,
•if you see streaks, you should turn the regulator to a lower number.
•if you see water spots, you should turn the regulator to a higher number.
Rinse Agent Indicator Light
An additional rinse aid indicator light is on the control panel. When the rinse agent dispenser is empty, the indicator light will glow and the level indicator will show a silver background with black lines.
After filling the rinse agent dispenser, close the door and wait a few minutes for the indicator light to regis- ter.
To adjust Rinse |
|
Agent Regulator |
|
Setting: |
|
1. Open the cover |
|
of the rinse agent |
|
dispenser. |
|
2.Turn the setting |
|
indicator to the de- | Figure 15 |
sired setting. |
NOTE: Refill rinse agent when the level indicator shows a silver back- ground with black lines.
Figure 16
Rinse agent level indicator
Rinse agent is available in liquid or solid form. Only use the liquid type of rinse agent in the Thermador dishwasher.
Figure 17
Page 10