Thermador DW44ZSB, DW44ZW, DW44ZP manual Change Cycle, Cancel Cycle

Cycle Interruption

As a safety feature the dishwasher will automatically turn itself off whenever the door is opened. However, if the door is opened quickly while in a wash or rinse cycle some water may splash out of the dishwasher. For this reason it is recommended that the machine always be switched off before opening the door.

To Interrupt a Cycle

1.Press the on/off button to stop operation.

2.Wait at least 10 seconds (or until the water noises stop) before opening the door.

To Resume a Cycle

1.Push the on/off button and close the door.

Changing a Cycle

To change the cycle selection, press the program but- ton of the desired cycle TWICE. The chosen cycle button (or the light above it) becomes illuminated, showing that it has been selected.

Canceling a Cycle

1.Press the cancel drain buttons at the same time and hold for approximately 3 seconds.

2.When the drain pump noises stop and the LED display or clean light indicate that the end of the cycle has been reached, the dishwasher is reset.

3.Press the on/off button to turn the dishwasher off.

4.The dishwasher is now ready to run a selected cycle. Add more detergent if necessary.

WARNING

DO NOT PULL DOOR FULLY OPEN WHILE DISHWASHER IS IN OPERATION. QUICKLY OPENING THE DOOR WHILE DISHWASHER IS IN OPERATION COULD RESULT IN SERIOUS SCALDING.

ON/OFF BUTTON

On

Off

Figure 20

CHANGE CYCLE

Figure 21

CANCEL CYCLE

Figure 22