Samsung RF263BEAESP, RF263BEAEWW, RF263BEAEBC, RF263BEAESR Completing the set up, setting up

Refrigerator

Plastic Tubing

Compression		(Assembled)
Nut (1/4”)
		Compression
(Assembled)
		Fitting
		(Assembled)
Ferrule		Molded
		end(Bulb)
(Not supplied)
		Compression
		nut (B) (1/4”)
		(Not supplied)
Copper tubing	or	Plastic tubing (B)
(Not supplied)		(Not supplied)

Household water supply line

111 Connect the household water line to the assembled compression fitting.

-- If you are using copper tubing, slip the compression nut ( B ) (not supplied) and ferrule (not supplied) on the copper tubing (not supplied) as shown.

-- If you are using plastic tubing ( B ) , insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting.

Do not use without the molded end (Bulb) cAuTION of the plastic tubing ( B ).

222 Tighten the compression nut ( B ) onto the compression fitting.

Do not over-tighten the compression nut ( B ) .

333 Turn water on and check for any leakage. If you find water drops or leakage in the connection areas, turn off the main water supply. Check the connections and, if necessary, tighten.

444 Flush 1 gallon of water through the filter before drinking or using the water from the refrigerator. (Flush approximately 6 minutes.) To flush, press a large glass or cup against the water dispenser lever. Fill the glass, empty it into the kitchen sink after it is filled, and then repeat.

555 After you turn on the refrigerator, let the ice maker make ice for 1 to 2 days. Over that period of time, throw out the first 1 or 2 buckets of ice the freezer makes to ensure all impurities have been removed from the water line.

Only connect the water line to a drinkable
water source.
If you have to repair or disassemble the water line,
cut off 1/4“ of the plastic tubing to make sure you
get a snug, leak-free connection.	up

Completing the set up

Now that you have your new refrigerator installed	01setting
By completing the following steps, your refrigerator
in place, you are ready to set up and enjoy the
features and functions of the appliance.
should be fully operational.
111 Make sure your refrigerator is in an appropriate
location with reasonable clearance between it
and the wall. Refer to installation instructions in
this manual.
222 Once the refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
333 Set the Temperature control to the coldest
temperature and wait for an hour. The freezer
will get slightly chilled and the motor will run
smoothly. Reset the refrigerator and freezer to
the temperatures you want.
444 After you plug the refrigerator in, it will
take a few hours to reach the appropriate
temperature. You can store food and drinks
in the refrigerator after the temperature is
sufficiently cool.

setting up _11

DA68-02601A(EN+FR+ES)-0.2.indb 11

2012.3.31 9:49:44AM