INSTALLATION OF THE WATER DISPENSER LINE
Adjust the amount of water supplied.
1)In order to set the display panel to the option mode, press the Freeze Temp. and Power Cool buttons at the same time for about 12 seconds until the temperature display panel switches to the option mode and you hear a beep.
2)A number under “Fridge Temp.” corresponds to the option number. Press the Fridge Temp. button to increase the number and the Power Cool but- ton to decrease the number. Set the option number 3.
Option number
3)Now, you have to select the “Input Data” to control the water supply time. Press the Freeze Temp. button to increase the value. Press the Power Freeze button to decrease the value.
Choose the right amount of water supplied to the ice tray
4)Wait until the display panel automatically switches back to the control mode.
| Input Data | Water Supply Time (sec) |
| 00 | 5 |
| 01 | 4 |
| 02 | 3 |
| 03 | 6 |
| 04 | 7 |
| 05 | 8 |
| 06 | 9 |
| 07 | 10 |
| 08 | 12 |
0913
1015
1117
1219
1321
1423
1525
NOTE
Input Data
When setting the “Input Data” do not select the largest number. The largest number may cause a overflow. Proceed step by step.
5) Check the amount of water supplied to the ice tray as shown
CHECK THE WATER LEVEL
OPTIMUM
LEVEL
29