CHECKING THE WATER DISPENSER LINE
A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote better
health, the Samsung water lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a water pressure of 20~125 psi (pound per square inch) is required. Under normal conditions, a 170 cc (5.75 oz.) paper cup can be lled in 10 seconds.
If the Refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure.
After installing the water dispenser line, make sure the water storage tank inside the Refrigerator is properly lled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer. We recommend using a water supply kit that contains copper tubing.
Connecting to the water supply line
1.First, shut o the main water supply line.
2.Locate the nearest cold, drinking water line.
3.After complete the water supply installation (Water Line & Filter), turn your main water supply back on and ush 3 gallons(Flush approximately 6 minutes) into a bucket to clear and prime the water lter.
1Cold water line
01 SETTING UP
2 Pipe clamp
4 Shut o valve
3 Water line installation kit
setting up _19