Samsung RFG297HDBP, RFG297HDWP Using the Cold Water Dispenser, Controlling the fridge temperature

Controlling the fridge temperature

The fridge temperature can be set between between 34°F and 46°F (or between 7°C and 1°C) to suit your particular needs. Press the Fridge button repeatedly until the desired temperature is shown in the temperature display. The temperature will change by 2°F (or 1°C) with each press. See below.

Fahrenheit : 38°F ➞ 36°F ➞ 34°F ➞ 46°F ➞ 44°F ➞ 42°F ➞ 40°F ➞ 38°F.

Centigrade : 3°C ➞ 2°C ➞ 1°C ➞ 7°C ➞ 6°C ➞ 5°C

➞4°C ➞ 3°C.

The temperature control process for the Fridge works just like the Freezer process. Press the Fridge button to set your desired temperature. After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display.

Recommend Temp (Fridge) : 38°F (or 3°C )

-The temperature of the Freezer, Fridge or Pantry Room may rise when you open the doors too

frequently, or if a large amount of warm or hot food is placed inside.

-This may cause the digital display to blink. Once the freezer and Fridge temperature return to their normal set temperatures, the blinking will stop.

-If the blinking continues, you may need to “reset” the refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in.

-If there is a communication error between the Display and Main Controller, the Pantry Display light may blink. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center.

USING THE COLD WATER

DISPENSER

Push the appropriate ice type button to select what you want dispensed.

14_ operating

NO ICE

Select this if you want to turn ice maker off

Using the ice Dispenser

Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass. Make sure the glass is in line with the dispenser to prevent the ice from bouncing out.

Please wait 2 seconds before

CAUTION removing the glass under the dispenser to prevent spills.

If the Refrigerator door opens, the Dispenser does not work.

When Cubed Ice is selected after using the

CAUTION Crushed Ice mode, a small amount of residual crushed ice might be produced.

Do not pull the lever out. You could damage CAUTION or break the lever's spring.

• To clean the ice bin/
bucket, wash with a	check the
mild detergent, rinse
	water level
well, and dry thoroughly
it. Do not use harsh or
abrasive cleaners or
solvents.
• When you select	Test button
Cubed Ice after using
the Crushed Ice mode,
a small amount of
residual crushed ice might be produced.

•If ice doesn’t come out, pull out the ice bucket and press the test button located on the right side of ice maker.

•Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice may jam the bucket.

•Normal Use

To fill the ice bucket to maximum capacity after installation, follow these steps:

1. Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).

-Waiting 24 hours will allow your ice maker to cool properly.

DA68-02488A-09.indb 14 13. 4. 25.

�� 2:08