CD Operation
English
IMPORTANT:
The lens of the CD player should never be touched.
5To pause playback press 2;. Press 2; again to resume play.
➜ The display freezes and the current track number flashes when playback is paused.
6To stop disc playback, press 9.
Note: CD play will also stop when;
– the CD door is opened.
– the disc has reached the end.
– you select another source: TAPE,TUNER.
– you select standby.
– you press the tape deck PLAY 2 key.
Selecting a different track
●Press ¡1 or 2™ (í or ë on remote control) once or repeatedly until the desired track number appears in the display.
●If you have selected a track number shortly after loading a disc, or in the PAUSE position, you will need to press 2; to start playback.
Playing a disc
This CD player plays Audio Discs including CD- Recordables and
¶
1Select CD source.
2Press OPEN•CLOSE on the top of the system to open the
CD compartment.
➜OPEN is displayed when you open the CD compartment.
3Insert a disc with the printed side facing up and press down on OPEN•CLOSE to close the CD door.
➜rEAd is displayed as the CD player scans the contents of a disc. The total number of tracks are also shown.
4Press 2; to start playback.
➜Current track number followed by elapsed playing time of the track are displayed during disc playback.
Finding a passage within a track
1Press and hold down ¡1 or 2™ (à or á on remote control).
➜The disc is played at high speed and low volume.
2When you find the passage you want, release ¡1 or 2™ (à or á on remote control).
➜Normal playback continues.
Note:
–During a disc programme or if SHUFFLE/ REPEAT active, searching is only possible within the same track.
12