Installation Instructions

BEFORE USING YOUR BEVERAGE COOLER

∙Remove the exterior and interior packing.

∙Check to be sure you have all of the following parts:

1 Instruction Manual

3 Beverage Shelves

2 Wire Baskets

2 Keys

∙Before connecting this appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

∙Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR BEVERAGE COOLER

∙This appliance is designed to be for free standing installation or built-in (fully recessed).

∙Place your Beverage Cooler on a floor that is strong enough to support it when it is fully loaded. To level your Beverage Cooler, adjust the front leveling legs at the bottom of the Beverage Cooler.

∙Locate the Beverage Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.

∙Avoid locating the unit in moist areas.

∙Plug the Beverage Cooler into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center.

BUILT – IN CABINET INSTRUCTIONS

This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built- in application please follow the requirements shown to the right.

← Figure shown

Cabinet Opening Dimensions

IN (min) MM (min)

Width 24” 610 mm

Depth 26” 661 mm

Height 35” 889 mm

			Figure shown →
	Unit Dimensions
		IN (min)		MM (min)
Width		23 1/2”		597 mm
Depth		24 ½”		623 mm
(with handle)
Depth		22 ¾”		578 mm
(without Handle)
Height		35”		889 mm
			9