Avanti BCA57SSR instruction manual Troubleshooting Guide, Problem Possible Cause

PROBLEMS WITH YOUR BEVERAGE COOLER?

You can solve many common Beverage Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer.

TROUBLESHOOTING GUIDE

PROBLEM	POSSIBLE CAUSE
Beverage Cooler does not operate.	Not plugged in.
	The appliance is turned off.
	The circuit breaker tripped or a blown fuse.
Beverage Cooler is not cold enough.	Check the temperature control setting.
	The door is opened too often.
	The door is not closed completely.
	The door gasket does not seal properly.
Turns on and off frequently.	The room temperature is hotter than normal.
	A large amount of contents has been added to
	the Beverage Cooler.
	The door is opened too often.
	The door is not closed completely.
	The temperature control is not set correctly.
	The door gasket does not seal properly.
The light does not work.	Not plugged in.
	The circuit breaker tripped or a blown fuse.
Vibrations.	Check to assure that the Beverage Cooler is
	level.
The Beverage Cooler seems to make too much	The rattling noise may come from the flow of the
noise.	refrigerant, which is normal.
	As each cycle ends, you may hear gurgling
	sounds caused by the flow of refrigerant in your
	Beverage Cooler.
	Contraction and expansion of the inside walls
	may cause popping and crackling noises.
	The Beverage Cooler is not level.
The door will not close properly.	The door is misaligned.
	The Beverage Cooler is not level.
	The gasket is dirty.
	The shelves are out of position.
Display flashes Error message “E0”	Connection failure – there is a wire or component
	that is not connected correctly.
	Contact the Avanti Service Department –
	1 – 800 – 220 – 5570
Display flashes Error message “E1”	Temperature sensor failure.
	Contact the Avanti Service Department –
	1 - 800 – 220 – 5570
Display flashes Error message “E2”	Defrost sensor (Coil Sensor) failure.
	Contact the Avanti Service Department –
	1 - 800 – 220 – 5570
Display flashes Error message “HH”	Temperature of inner cabinet is over 99ºF / 37ºC
Display flashes Error message “LL”	Temperature of inner cabinet is under 32ºF / 0ºC

12