Philips MCD759D Getting Started, Selecting the colour system that Corresponds to your TV

the Remote Control

3

1

2

1 Open the battery compartment.

2 Insert two AAA batteries following the indications (+/-) inside the compartment.

3 Close the cover.

Using the Remote Control to operate

the Player

1 Aim the Remote Control directly at the remote sensor

(IR) on the front panel.

2 Do not put any objects between the Remote Control and the DVD Player while

operating the DVD Player.

CAUTION!

– Remove batteries if

they are exhausted or if the Remote Control is not being used for a long time.

– Do not use old and new or different types of batteries in combination.

– Batteries contain chemical substances, so they should be disposed of properly.

Step 2: Setting up the TV

IMPORTANT!

Make sure you have completed all the necessary connections. (See “Connecting TV”).

1 Switch the DVD system on and then select DISC source. (See “Switching the system on/off”).

2 Turn on the TV and set to the correct video-in channel.You should see the blue Philips DVD background screen on the TV.

➜ Usually these channels are between the lowest and highest channels and may be called FRONT, A/V IN, or VIDEO. See your TV manual for more details.

Step 1:

Inserting batteries into

Getting Started

➜Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.

➜Or, the TV Remote Control may have a button or switch that chooses different video modes.

➜Or, set the TV to channel 3 or 4 if you are using an RF modulator.

Selecting the colour system that

corresponds to your TV

This DVD Player is compatible with both NTSC and PAL. In order for a DVD disc to play on this Player, the colour system of the Disc, the TV and the DVD Player should match.

1Press SYSTEM MENU in full stop mode.

2Press 1 2 to select “PREFERENCE PAGE”.

3Use 1 2 3 4 on the remote to navigate in the menu.

Move to “TV TYPE” and press 2.

➜PAL: Select this if the connected TV is PAL system. It will change the video signal of a NTSC disc and output in PAL format.

➜Auto: Select this if the connected TV is compatible with both NTSC and PAL (multi- system).The output format will be in accordance with the video signal of the disc.

➜NTSC: Select this if the connected TV is NTSC system. It will change the video signal of a PAL disc and output in NTSC format.

4Select an item and press OK.

Note:

–Before changing the current TV Type setting, ensure that your TV supports the selected TV Type.

English

19