MAINTENANCE
LAMP REPLACEMENT
DANGER
Before servicing unit, disconnect electrical service. Failure to disconnect electrical service could result in electrical shock and cause personal injury or death.
Remove lamp by rotating lamp 90 degrees to align lamp pins with holder slots. Refer to
CONDENSATE REMOVAL
The evaporator drain pan is located in the base of the condensing unit. The evaporator pan should be cleaned periodically to prevent odors and maintain evaporating efficiency. The pan contains wicks to assist evaporation and should be replaced periodically.
CONDENSER
DANGER
Before servicing unit, disconnect electrical service. Failure to disconnect electrical service could result in electrical shock and cause personal injury or death.
For efficient operation, it is recommended that the condenser coil and fans be cleaned every 3 to 6 months. Remove front grille for access. Refer to Condenser Unit Servicing section on page 8.
Vacuum clean front surface of coil thoroughly or direct forced air through condenser fins. Failure to clean condenser can cause compressor malfunction and will void warranty.
CABINET EXTERIOR
Cabinets should be cleaned with a solution of mild soap and water or mild household cleaner. Do not use caustic soap or abrasive cleaners, since these might damage the cabinet finish. If stainless steel surface becomes discolored, scrub by rubbing only in direction of the finish grain. Do not use steel wool or rusting may occur. Refer to Table 4.
INTERIOR SURFACE
The inside of the cabinet is coated with
EVAPORATOR HOUSING
DANGER
Before servicing unit, disconnect electrical service. Failure to disconnect electrical service could result in electrical shock and cause personal injury or death.
Evaporator and other enclosed parts normally will not require cleaning.
In case there’s some spillage refer to Evaporator Compartment Servicing section on page 9 to open the compartment.
Side walls and cover should be cleaned as described in Interior Surface section in this page.
12