Carrier Miracool owner manual Condensate Disposal, To Install Shelves

Page 5

INSTALL SHELVES

Product shelves and a bag containing shelf support clips are packed inside the unit. Refer to Table 1 to verify quantity of shelves and shelf supporting clips. Bottom shelf must be placed on interior floor and should be inserted into the two retainer clips provided at the rear corners or the unit floor.

WARNING

Improper shelf clip installation may cause shelf and/or product to fall which could result in personal injury or damage to the unit.

WARNING

Do not overload the shelves. The unit is designed to use all the shelves provided, installed in equally spaced configuration. Failure to install shelves correctly could result in personal injury or damage to the unit. If fewer shelves or a different installation configuration is desired, contact the manufacturer to ensure that shelf overloading will no occur.

 

TO INSTALL SHELVES

1.

Determine proper location for shelf clips.

 

Refer to the numbers on the pilaster to

 

ensure that all clips are properly located.

2.

Insert top tab of the shelf clip into the

 

desired hole of the pilaster. The retaining

 

tab should be facing upward as shown in

 

Figure 4.

3.

Rotate the clip downward and insert the

 

bottom tab into the appropriate hole on the

 

pilaster. If necessary, squeeze the clip

 

slightly during installation.

4.

Install all remaining clips as described

 

above.

5.

Install shelves onto clips so that the product

 

retention bar is facing upward. Be careful

 

not to dislodge clips during shelf installation.

6.

Shelves must be placed so that the retaining

￿

tab on the shelf captures the shelf as shown

 

in Figure 5.

7.

Before loading the shelf, ensure that the

 

shelf is resting on each of 4 clips and that

 

the clip are installed as shown in Figures 4

 

and 5.

FIGURE 4 – SHELF CLIP INSTALLATION

FIGURE 5 – PROPER INSTALLATION OF

SHELF ON CLIP

CONDENSATE DISPOSAL

The evaporator drain pan is located in the base of the product. Airflow in compartment hastens condensate evaporation so that external drain plumbing is not required.

5

Image 5
Contents Miracool Glass Door Merchandiser 2000L Installation ContentsGeneral Unit InspectionMiracool Bottle Cooler Unit Components MC2000H Shown To Level Unit To Gain Access to Leveling FeetLevel Unit Condensate Disposal Install ShelvesTo Install Shelves START-UP BI-PIN Fluorescent Lamp Installation / VerificationPreliminary Checks Electrical Supply and ConnectionsTemperature Control Power SupplyInitial START-UP Unit DataComponents Refrigeration System ServiceService Troubleshooting Charging Refrigeration System EvacuationRefrigeration System Refrigeration System Service and Analysis ChartMalfunction Possible Cause Solution Wiring Diagram Maintenance Task Cleaning Agent Method of Application Effect on Finish Methods for Cleaning Stainless SteelCopyright 2006 Carrier Corporation