Roper B875, MN11020(344197) manual Before Calling For Service, Adjusting Oven Temperature

Before Calling		for	Service
r				DON’T CALL FOR SERVICE
I	PROBLEM	POSSIBLE	CAUSE
				UNTIL YOU CHECK

l	Foods do not broil	.	Improper	rack position
	properly.
		l	Oven preheated
		.	Improper	utensil	used
		.	Improper	broiling	time

. Check broil pan placement; see Broiling section.

. Do not preheat when broiling.

. Use broiler pan and grid supplied with range.

*Check broiling chart.

!l

l

-

l

Oven smokes,

Oven light or work light does not work (if equipped).

Oven does not clean or poor cleaning results (Self-clean models only).

Oven door will not unlock (Self-clean models only).

lDirty oven

lBroiler pan full of grease left in oven

9	Light	switch	in off position
. Light		bulb or	fluorescent	light
	starter	burned out
9	Controls not		set properly
. Clean		cycle	interrupted	too
	soon

lOven too dirty

lClean cycle not complete

9 Check for heavy spillover.

. Clean pan and grid after each use

lCheck switch setting.

lCheck or replace light bulb or fluorescent light starter; see use and care instructions.

lCheck self-clean instructions.

nHeavrly soiled ovens require a 3 l/2 hr. clean cycle.

lHeavy spillovers should be removed before setting clean cycle.

lOven must cool below lock temperature (20 to 30 minutes after clean cycle is complete).

0 Tone does not sound

. Tone has been eliminated by pushing and holding CANCEL button

. Push and hold CANCEL button to activate tone.

ADJUSTING OVEN TEMPERATURE

The temperature in your new oven has been set correctly at the factory, so be sure to follow the recipe temperatures and times the first few times you bake in your new oven.

If you think the oven should be hotter or cooler, you can adjust it yourself. To decide how much to change the temperature, set the oven temperature 25°F higher or lower than the temperature in your recipe, then bake. The results of this “test”should give you an idea of how much the temperature should be changed.

To Adjust Oven Temperature:

1.Push the BAKE button.

2.Select a temperature between 500°F and 550’F with the SET knob.

3.Quickly (within two seconds, before the BAKE Function energizes) push and hold the BAKE button.

The display will change to the amount of degrees difference between the original factory temperature setting and the current temperature setting. If the oven has the original factory setting, the display will read 00.

4.The temperature can be adjusted up to 35°F hotter or cooler (in 5°F steps), by turning the SET knob. A minus sign (-) before the number means that the oven will be cooler by displayed amount of degrees.

5.When you have made the desired adjustment, push the CLOCK button to go back to the time of day display or use your oven as you would normally.

Note: The self-clean temperature will not be changed by the adjustments described above.

22 GSER27