REMOVABLE OVEN DOOR
The oven door can be removed for cleaning.
1.Open the door to the broil stop position (see illustration).
2.Grasp the door at each side and lift up and off the hinges.
NOTE: When the door is removed and hinge arms are at stop position, do not bump or try to move the hlnge arms. The hinges could snap back causing an injury to the hands or damage to the porcelain on the front of the oven. Cover the hinges with toweling or empty towel roils while workin‘g in the oven area.
To replace:
1.Hold the door over the hinges with the slots at the bottom edge of the door lined up with the hinges. The hinge arms must still be in the stop position.
2. Slide the door down onto the hinges as far as it will go and | POSITION |
| |
close the door. |
|
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when installing or removing oven racks.
To install:
1.Set the raised back edge of the rack on a pair of rack guides.
2.Push the rack in until you reach the bump in the rack guide, then lift the front of the rack a bit and push the rack ail the way in.
To remove:
1.Pull the oven rack out, then up.
REPLACING THE OVEN LIGHT (some models)
Do not touch oven bulb when hot, with wet hands, or wipe oven light area with wet cloth.
Never touch the electrically live collar on the bulb when replacing it.
Electrical power must be shut off if you have to replace a broken bulb.
1Remove the three screws and lift off the glass retainer. glass cover and gasket
2Replace the bulb with a 40 watt appliance bulb. An (appliance bulb is smaller than a standard 40 watt house- lhoid bulb.
3.Replace the gasket, glass cover and glass retainer. Tighten screws securely.
GASKET
BULL3
COLLAR
20GMNT30