BLOCKING FOR SAFETY
Mounting the anti tipping device on concrete floors
Secure the appliance in place so it does not tip for- ward when the fully stocked doors are opened. The anti tipping bracket is provided with the appliance.
1.Mark the center line of the appliance on the back wall. Align the anti tipping bracket center to this line.
Be sure that there is no plumbing or electrical wiring located in this area which screws or drills could damage.
2.Drill a 3/8" diameter hole in any position as shown in Figure 9 using a carbide drill bit.
The depth of the holes must exceed the overall length of the anchors provided.
Clean the holes after drilling.
3.Attach washer and screw on hex nut to the end of each anchor.
Drive in all 3 anchors.
Align the bracket center to the center line on the back wall again.
Fasten the anchors by turning the hex nut.
4.Fasten bracket with 3 screws (1/4" x
Wall
Wall Plate
Wall
Figure 8
Wall Plate | Figure 9 |
10