Maintenance
w The SuperFrost button will flash w S will appear on the display.
u Using the freezer compartment Up button () or freezer compartment Down button (), select F.
u To confirm: Briefly press the SuperFrost Fig. 2 (9) button.
w F0 will appear on the display.
u To confirm: Briefly press the SuperFrost Fig. 2 (9) button.
w The filter symbol Fig. 2 (5) goes out
6.2 Defrosting with NoFrost
The NoFrost system defrosts the appliance automatically. The moisture condenses on the evaporator and is periodi- cally defrosted and evaporated.
u The appliance does not need to be defrosted manually.
6.3 Cleaning the appliance
WARNING Danger of electric shock.
u Unplug refrigerator or disconnect power.
WARNING
Risk of injury or damage due to hot steam.
Hot steam can cause scalding/burns and damage to surfaces.
u Do not use steam cleaners.
NOTICE
Incorrect cleaning damages the appliance. u Do not use concentrated cleaning agents.
u Do not use steel wool or sponges that scour or scratch. u Do not use caustic or abrasive cleaning materials or those containing sand, chloride, chemicals or acids.
u Do not use chemical solvents.
u Do not damage or remove the rating plate on the inside of the appliance. It is vital for the customer service department.
u Do not pull off, kink or damage any cables or other components.
u Do not let cleaning water get into the drain gutter, the ventilation grille and electrical parts.
u Use soft cleaning cloths and a
u Only use
u Empty the appliance.
u Disconnect the power plug.
u Clean the plastic surfaces, outside and inside, by hand using lukewarm water and a little dish washing liquid.
Stainless steel which is exposed to chlorine gas or damp- ness may become discolored. This is normal. If your appliance is exposed to chlorine gas or dampness, clean and polish it more frequently. If there are any signs of rust or discoloration, clean and polish the appliance as soon as possible.*
Do not apply stainless steel cleaning agents to glass or plastic surfaces so as not to scratch them. Initially darker areas and quite an intensive color of the stainless steel surfaces are normal.*
u If dirty clean external stainless steel surfaces with a commercially available stainless steel cleaning agent. Then apply the supplied stainless steel cleaning agent evenly in the direction of the grain.*
u Clean fittings by hand using lukewarm water and a little dish washing liquid.
After cleaning:
u Wipe the appliance and accessories dry.
u Connect the appliance and switch it on again. u Switch on SuperFrost (see 5.10) .
When the temperature is sufficiently cold: u put the food back in the appliance.
6.4 Cleaning the IceMaker
The IceMaker drawer must be emptied and pushed in.
u Activate setting mode: press and hold the SuperFrost button Fig. 2 (9) for approximately 5 s.
w S is shown on the display.
w The Menu symbol Fig. 2 (3) lights up.
u Using the Up button Fig. 2 (1)/ Down button Fig. 2 (2), select I.
u To confirm: press the SuperFrost button Fig. 2 (9). u Using the Up button Fig. 2 (1)/ Down button
Fig. 2 (2), select Ic.
u To confirm: press the SuperFrost button Fig. 2 (9).
w The IceMaker moves into cleaning position and shuts off.
u Deactivate setting mode: press the On/Off button Fig. 2 (8).
u Wait 2 min.
w The temperature is again displayed on the temperature display.
u Take out the drawer.
u Clean the ice compartment and drawer with warm water. If necessary, use a mild dishwashing liquid. Then rinse.
u Slide the drawer back in.
If dishwashing liquid was used:
u Throw out the first three batches of ice cubes to get rid of any dishwashing liquid residues.
Either leave the IceMaker switched off in this position or switch the IceMaker back on (see 5.16) .
12 | * Depending on model and options |
|