TroubleshootingNet@Home
Customer service and type plate
If none of the above causes apply and you cannot
rectify the fault yourself, or if the temperature display reads "F 1 " to " F 5", this means that there is a fault. Please contact your nearest customer service department (see enclosed list for addresses). Give the fault number dis- played, together with the
type designation 1, service number 2 and appliance number 3
as given on the type plate, fig. A2, so as to ensure rapid, ac- curate servicing. The type plate is located inside the freezer compartment on the
Leave the appliance shut until the customer service engi- neer arrives so as to prevent any further cold loss.
Depending on the model and equipment, your appliance may have an additional interface to which you can connect
an optional Net@Home module.GB You can choose between a TeleSafe module and a home
bus slave module. The modules are available from your dealer.
If your appliance has this interface 1, it will be located at the back of the appliance near the top:
1
TeleSafe module
The TeleSafe module informs you immediately if your appli- ance develops a fault.
In the event of a temperature alarm, mains failure or another fault display (F1 to F5), the fault status is immediately for- warded to the alarm contact.
The alarm contact can be connected to any of the following processing units:
-a telephone system with an appropriate signal input,
-an
-an automatic telephone dialling and announcement unit. In the event of an alarm a programmable number is di- alled and a recorded message is played back.
Home bus module
The home bus slave module enables you to integrate your appliance into a home network (EHS Powerline). You can then
-operate all the functions of the appliance or
-display the status of the appliance, e.g. door open alarm, current refrigerator/freezer temperature, or
-assemble the Liebherr HomeDialogSystem.
In this way a freezer installed in the basement can be controlled via the display on the combined refrigerator- freezer in the kitchen (setting the temperature, switching SuperFrost or DuraFrost on and off). All display functions (temperature, door alarm, mains failure) can also be called up.
For more information, please visit our website at www.liebherr.com
GN/SGN/es..6 | 19 |