Mounting the ventilation grille
Pull out the bottom freezer drawer.
1. Remove the blue protection film from the dust filter provided and insert the filter into its opening
in the plinth. Engage the filter at the bottom, press down the button and click into place.
1.
5.Insert the locking pins to block the sup- ports.
5.
2.Remove the locking pins of both supports. The supports are provided with the appli- ance accessory pack.
6.Install the ventilation grille.
The grille has bolts on the inside (see detail in the drawing below). These bolts must be inserted into the holes of the supports.
2.
3. Insert the supports for the ventilation grille on the left and right sides in the motor compartment.
6.
4.The front edge of the brackets is flush with the front of the ventilation grille.
Adjustthesupportsaccordingly.
3. | 7. | Adjust the height of the ventilation grille. |
• | Loosen the grub screws at the front of the grille (Allen key | |
|
| A/F 2.5). |
| • | Adjust the ventilation grille to the desired height. |
• Tighten the grub screws.
7. 4. 
8