Rangemaster U109952 - 02 manual To Remove the Grill Door, To Remove an Oven Inner Back

Page 27

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

16.To Replace an Oven Door Seal

Open the oven door. The seal has small hooks that hold it in place by locating into holes in the rear door face on the main oven and oven front face on tall oven. At the corner, pull the seal diagonally away from the door centre until the hook is released (Fig.8-9). Proceed to the next hook and release it in a similar way, and so on.

You can use force if the hooks are stiff, as the old seal will be discarded.

Carefully lift away the inner back. Reassemble in reverse order making sure that the four screws and washers are fully tightened.

ArtNo.320-0004 Oven door keep

Fig.8-8

Fig.8-9

17. To Remove the Grill Door

Remove the control panel (see 1). Remove the left-hand side panel (see 2). Remove the centre cover strip (5 screws, 2 top, 2 bottom, 1 in middle). Remove the two countersunk screws (1 each side) securing the grill hinge arms to the front of the grill chamber.

Note: The arms are spring tensioned. Carefully remove the grill door. Retain the gaskets.

Reassemble in reverse order ensuring that the gasket is fitted between the hinge arm and the front of the grill chamber.

18. To Remove an Oven Element Thermal Cut-out

ArtNo.320-0005 Oven door rubber seal

Fig.8-10

Disconnect from electricity supply.

 

Pull the cooker forward to gain access to the cover box. Undo the cover screws and lift clear. The cutout is located on the earth plate beside the oven element connections. Disconnect the cutout wiring. Undo the fixings that secure the cutout to the earth plate and remove. Fit the replacement control and re-assemble in reverse order.

19.To Remove an Oven Inner Back

Disconnect from electricity supply.

Open the door and remove the shelves. Remove the screws and washers securing the inner back to the back of the oven (Fig.8-10). Carefully lift away the inner back. Reassemble in reverse order making sure that the screws and washers are fully tightened.

20.To Remove the Fan Oven Element

Disconnect from electricity supply.

Remove the oven inner back (see 19). Remove the two screws from the top of the element and the one from the bottom of the element inside the oven (Fig.8-11).

Lift the element out carefully, disconnecting the terminals connected to the element (noting their positions).

If it is not possible to disconnect the leads in this way, pull the cooker forward to gain access to the rear.

Remove the screws securing the electric cover to the back sheet, remove the cover and disconnect the terminals from the rear.

ArtNo.320-0020 Oven back fixing screws

Fig.8-11

��������������������

ArtNo.321-0005 Fan oven element

25

Page 26 Page 28
Image 27
Page 26 Page 28
Contents User Guide Contents Peculiar Smells Installation and MaintenancePersonal Safety Before You Start do not use the hob surface as a cutting board CleaningHob Care Cooker CareHob Cooker OverviewResidual Heat Indicator, H Pan DetectorAutomatic Heat-up, a Grill Child Lock, LBoil Dry Function Ovens  Never close the grill door when the grill is onTo stop the oven automatically Setting the time of daySetting the minute minder ClockKey Lock Auto is showing, you want to reset to manual cookingHandyrack Main Oven AccessoriesOven Shelves Left-hand Main Oven Oven shelves Right-hand Tall OvenMain Oven Light Tips on Cooking with the Timer Cooking TipsGeneral Oven Tips Meat Fan Oven Cooking TableDaily Care Cleaning Your CookerCleaning Spills Cleaning Burned-on SpillsDo not use any abrasive substances ‘Cook & Clean’ PanelsControl Panel and Doors Door PanelTall Oven Removing the Panels to clean the Enamel InteriorTroubleshooting Food is cooking too slowly, too quickly, or burning Timed oven is not coming on when turned on manuallyTimed oven is not coming on when automatic cooking Oven temperature getting hotter as the cooker gets olderProvision of Ventilation InstallationDear Installer Safety RequirementsPositioning the Cooker Unpacking the CookerMoving the Cooker Lower the Two Rear Rollers Completing the MoveRepositioning the Cooker following Connection LevellingOven Check Electrical ConnectionHob Check Grill CheckTo Replace a Hob Element ServicingTo Lift up the Ceramic Hob To Remove the Control PanelTo Remove the Electronic Timer To Replace a ThermostatTo Replace the Grill Controller  The door is heavy, so take care To Adjust an Oven Door AngleTo Adjust the Main Oven Door Catch Keep To Replace an Oven DoorTo Remove the Grill Door To Remove an Oven Inner BackTo Remove the Fan Oven Element To Replace an Oven Fan To Remove Grill ElementTo Change Oven Light Bulb Key Circuit Diagram OvenCircuit Diagram Hob Technical Data DimensionsConnections DocNo.000-0001 Back cover Rangemaster
Top Page Image Contents