Rangemaster U109952 - 02 manual To Replace an Oven Fan, To Remove Grill Element

Page 28

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

Fig.8-12

Fig.8-13

ArtNo.324-0007 Unscrewing the bulb cover

ArtNo.324-0005 Oven light bulb

21.To Replace an Oven Fan

Disconnect from electricity supply.

Pull the cooker forward to gain access to the rear. Remove the screws securing the electric cover to the back sheet and remove the cover.

Disconnect the three terminals connected to the fan noting their position. Remove the oven inner back (see 19). Hold the fan blade and remove the centre nut (left-hand thread) two brass washers, fan blade and circlip. Unscrew the fan retaining nuts and washers (three off each) and lift the fan away from the rear of the cooker. Fit the new fan and reassemble in reverse order. Check the operation of the oven.

22.To Remove Grill Element

Disconnect from electricity supply.

Remove grill pan from inside the grill compartment; remove the enamelled front shield from the grill roof, by undoing the two screws and washers.

Remove the two screws and washers securing the grill element front support. Remove the screws from the grill element.

Lift the element out carefully, disconnecting the leads from the element terminals (noting their position). If it is not possible to disconnect the leads in this way, pull the cooker forward to gain access to the rear, remove the screws securing the electric cover to the back sheet, remove the cover and disconnect the terminals from the rear.

Fit the new element and reassemble in reverse order. Check the operation of the grill.

23.To Change Oven Light Bulb

Disconnect from electricity supply.

Make sure the oven is cool. Open the oven door and remove the oven shelves. Remove the grill pan and support from the grill chamber.

Unscrew the bulb cover by turning anticlockwise. It may be very stiff (Fig.8-12).

Taking care to protect your fingers in case the bulb should shatter, unscrew the old bulb.

Fit an Edison screw fitting 15W 240V lamp, FOR OVENS. It must be a special bulb, heat resistant to 300°C (Fig.8-13).

Screw in the new bulb, and then screw back the bulb cover. Turn on the electricity supply and check that the bulb now lights.

26

Page 27 Page 29
Image 28
Page 27 Page 29
Contents User Guide Contents Installation and Maintenance Personal SafetyBefore You Start Peculiar SmellsCleaning Hob CareCooker Care  do not use the hob surface as a cutting boardCooker Overview HobPan Detector Residual Heat Indicator, HAutomatic Heat-up, a Child Lock, L GrillBoil Dry Function  Never close the grill door when the grill is on OvensSetting the time of day Setting the minute minderClock To stop the oven automaticallyAuto is showing, you want to reset to manual cooking Key LockAccessories Oven Shelves Left-hand Main OvenOven shelves Right-hand Tall Oven Handyrack Main OvenMain Oven Light Cooking Tips Tips on Cooking with the TimerGeneral Oven Tips Fan Oven Cooking Table MeatCleaning Your Cooker Cleaning SpillsCleaning Burned-on Spills Daily Care‘Cook & Clean’ Panels Control Panel and DoorsDoor Panel Do not use any abrasive substancesRemoving the Panels to clean the Enamel Interior Tall OvenTroubleshooting Timed oven is not coming on when turned on manually Timed oven is not coming on when automatic cookingOven temperature getting hotter as the cooker gets older Food is cooking too slowly, too quickly, or burningInstallation Dear InstallerSafety Requirements Provision of VentilationUnpacking the Cooker Positioning the CookerMoving the Cooker Completing the Move Repositioning the Cooker following ConnectionLevelling Lower the Two Rear RollersElectrical Connection Hob CheckGrill Check Oven CheckServicing To Lift up the Ceramic HobTo Remove the Control Panel To Replace a Hob ElementTo Replace a Thermostat To Remove the Electronic TimerTo Replace the Grill Controller To Adjust an Oven Door Angle To Adjust the Main Oven Door Catch KeepTo Replace an Oven Door  The door is heavy, so take careTo Remove an Oven Inner Back To Remove the Grill DoorTo Remove the Fan Oven Element To Remove Grill Element To Replace an Oven FanTo Change Oven Light Bulb Circuit Diagram Oven KeyCircuit Diagram Hob Dimensions Technical DataConnections DocNo.000-0001 Back cover Rangemaster
Top Page Image Contents