Door Reversal

If required the opening direction of the door can be changed as follows:

To reverse the bottom hinge assembly proceed as follows:

Disconnect the appliance from the electricity supply.

Tilt the appliance backwards, resting the top edge of the appliance on a stool or something similar.

Unscrew the adjustable feet situated on both sides (2 pieces), in addition the screws fixing the lower door holders (3 pieces) respectively the screw on the other side.

Take off the freezer door by pulling it slightly downwards.

Unscrew the top door hinge pin of the refrigerator then screw it back on the other side.

Fit the freezer door on the upper door hinge pin.

Put over the pin in the lower door holding plate in the direction of the arrow.

Fix the plate on the other side leaving the position of the door unchanged.

Then screw in the one screw in the place set free on the other side as well as the adjustable feet (2 pieces) and set up the box.

Put over the handles on the other side and put the plastic covering nails supplied in the plastic bag of this instruction book into the holes set free.

Put the appliance to its place, set it level and plug it into the mains socket.