Hill Phoenix KRZH instruction

CAULK

Remove Shipping Accessories From Case. Add Sealant.

Remove anything8from case that may interfere with case joining (eg. ship- ping braces). Run a bead of sealant around entire end before pushing cases tightly together.

4	5
3
2	1

Bolt Cases Together Using Bolt Holes Provided

Push cases9tightly together. Bolt cases together through the four holes provided. Tighten until all margins are equal; do not over tighten.

CAULK

Add Sealant to Top Case Joint.

Once cases10are pushed tightly together and bolted run a bead of sealant along the top joint.

ACRYLIC

TAPE

PIPE

CHASE

Caulk Pipe Chase, Install Acrylic Tape

Seal joints11along pipe chase seam with the caulk provided. Apply acrylic tape over pipe chase seam. Tape is found with the ship loose items and acts as a watershed preventing water from settling in case joint.

TANK	UPPER
	KICKPLATE
KICKPLATE	RETAINER
KICKPLATE
BRACKET
	“J” RAIL

Install Upper Kickplate Retainer & “J” Rail

Attach 12the upper kickplate retainer by placing it against the bottom of the tank. Line up the retainer with the kickplate bracket and attach with the screws provided. Set the “J” rail flush to the floor and attach it to the kickplate bracket with the screws provided.

	KICKPLATE
PEDESTAL	BRACKET

Install Pedestals

The pedestals13line-up at the corner of the case that is located at the end of a line-up. Attach the pedestal to the kick- plate bracket with the screws provided.

	UPPER
	KICKPLATE
	RETAINER
“J” RAIL	KICKPLATE
“J” RAIL

Insert Kickplate

END

KICKPLATE

PEDESTAL

BASEFRAME

Install End Kickplate


			BUMPER
TRACK			BUMPER
TRACK			TRIM

Install Bumper Trim

Insert top14of kickplate into the upper kickplate retainer. Slide the kickplate up into retainer then down on the “J” rail.

End kickplates15are installed only on cases with ends. Fit the end kickplate under the end and secure it to the base- frame.

Insert the16bumper trim into the track that is mounted to the front panel of the case.