APPENDIX - A
CLEANING INSTRUCTIONS FOR ANTIFOG COATING
Antifog Coating Cleaning Instructions (ANTIFOG B):
Materials
CAUTION:
1.Only use deionized or distilled water with 2% cleaning solution (P/N
2.Only use soft
3.Do not use abrasive compounds to clean the coating. Do not use razor blades or sharp instruments to remove residue from the coating.
Initial Cleaning (New Doors)
•Remove protective plastic film on the inside surface of the door.
•Apply diluted cleaning solution to the coating surface.
•Using gentle pressure, wipe glass over the entire surface with soft wipers once in the horizontal direction, followed by once in the vertical direction.
•Gently dry the surface of the coating with new wipers.
•Repeat the above cleaning and drying cycle two more times.
Periodic Maintenance Cleaning
•Apply diluted cleaning solution to the coating surface.
•Using gentle pressure, wipe the entire surface of the glass with soft wipers.
•If the solution freezes on the surface of the glass, do not attempt to scrape off the ice from the coating surface with force; either allow the inside surface of the door to warm up, or apply more deionized water on the coating surface until the ice has melted enough to be removed by gentle force.
•Gently dry the surface of the coating with new wipers.
•Please note that a newly cleaned freezer door glass will initially form a frost layer that will take several hours to completely dissipate.
26