Casters

CASES

MOVE ON

FOR EASIER INSTALLATION

KATS cases are manufactured and shipped to stores with casters installed on the base frame to make the job of moving cases easier for everyone involved with the manufacturing, shipping and installation process.

ROLL OUT OF TRUCK1. When there is a truck - level delivery dock (with 8’ ft. minimum opening), cases may be rolled directly from the truck to the store floor. [CAUTION] If skid boards are required to unload cases, casters should be removed prior to sliding them down the skid; after which they can be rein- stalled on case.

REMOVE COTTER PIN3. Removing the casters is easy. Simply flatten and hammer out cotter pins then lift the case with “J” bar, and the casters will fall off.

[CAUTION] Make certain hands are out of the way.

Casters not only speed up the process, but they also reduce the chance of damage from raising and low- ering cases with ”J” bar to place them on dollies, skates or rollers. In most situations, one or two per- sons can move the case with ease.

ROLL TO LINEUP POSITION2. Casters may remain in place to move the cases to staging areas around the store, prior to final installation. When ready for final line-up, roll the case to set position, then remove casters.

CASTERS MAY BE 4DISCARDED.