User Information Contd | hussman RHR2-HEX, rhr-hex, RHR-SQ manual

IGHT-RHR, RHR2-HEX-0608

User Information (Cont'd)

Cleaning Instructions

1 . Turn temperature control knobs to OFF position.

2.Allow unit to cool completely.

3.Wipe entire unit with clean cloth and mild detergent. The EXTERIOR surfaces of these hot tables must be cleaned with a mild detergent and warm water to protect and maintain their attractive finish. Never use abrasive cleaners or scouring pads.

TO REMOVE “BAKED-ON” SPLATTER, GREASE OR LIGHT DISCOLORATION TO STAINLESS STEEL.

CLEANSING AGENT	APPLICATION
Grade F Italian Pumice	Scour or rub with damp cloth
Liquid NuSteel	Scour with small amount on
	dry cloth
Paste NuSteel
Household Cleansers	Rub with damp cloth
TO REMOVE HEAT TINT OR HEAVY
DISCOLORATION
CLEANSING AGENT	APPLICATION
Allen Stainless Steel Polish	Small amount on damp
	cloth
Birdsall “Staybright”	Rub with damp cloth
Wyandotte
Bab-O
Nusteel	Rub with stainless steel
	wool

Plexiglass and Acrylic Care

Cleaning

Clean with plenty of nonabrasive soap (or detergent) and lukewarm water, using the bare hand to feel and dislodge any caked-on dirt. A soft, grit-free cloth, sponge, or chamois may be used, but only as a means of carrying the water to the plastic. Dry with a clean damp chamois or clean soft cloth such as cotton flannel. Hard, rough cloths or paper towels will scratch the acrylic and should not be used.

Waxing

If after removing dirt and grease, the acrylic can be waxed with a good grade commercial wax. This will improve the appearance of the surface by filling in most minor scratches. Wax should be applied in a thin even coat, and brought to a high polish by rubbing lightly with a dry clean soft cloth, such as a cotton flannel. Excessive rubbing may cause scratching and/or buildup an electrostatic charge, which attracts dust and dirt to the surface. Blotting with a clean damp cloth is recommended to remove charge.

Antistatic Coatings

For acrylic used indoors, antistatic coatings successfully prevent the accumulation of electrostatic charge for periods of several months, if the surface is not washed or wiped down with a wet cloth. Between applications of the antistatic coatings, the parts need only be dusted with a soft clean cloth to maintain a good appearance. In use, liquid antistatic coatings should be applied in a very thin even coat. If beads appear as it is applied, the coat is too thick and the excess should be removed with another cloth. Allow the coating to dry, then bring to a high gloss with a soft cloth.

Cleaning Precautions

To preserve the attractive finish, use warm water and a mild detergent to wash the exterior of the cases. DO NOT USE

ABRASIVE CLEANERS OR STEEL WOOL SCOURING PADS as these will mar the surface.