Door Closing and Door Alignment
The base grille covers the leveling screws and roller assemblies located at the bottom of the refrigerator cabinet below the freezer door or drawer. Before making adjustments, remove the base grille and move the refrigerator to its 
nal location.
1.Remove the base grille. Grasp the grille 
rmly and pull it toward you.
NOTE: Having someone push against the top of the refrigerator takes some weight o
the leveling screws. This
makes it easier to turn the screws.
2.Move the refrigerator to its 
nal location.
NOTE: To allow the refrigerator to roll easier, raise the leveling legs o
the 
oor by turning the leveling screws counterclockwise. The front rollers will be touching the 
r.
3.So the doors will close easier, use a ¹⁄
" hex driver to turn both leveling screws clockwise. This will raise the front of the refrigerator tilting it slightly downward to the rear. Turn both leveling screws the same amount.
NOTE: Having someone push against the top of the refrigerator takes some weight o
the leveling screws. This makes it easier to turn the screws.
"
A
A. Leveling screw
4.Open and close the doors to make sure they close as easily as you like. If not, increase the tilt by turning both leveling screws clockwise. It may take several turns of the leveling screw to allow the doors to close easier.
5.Check for door alignment. If one door is lower than the other, adjust the leveling screw, on the lower side of the refrigerator. Using a ¹⁄
" hex driver, turn the screw clockwise to raise that side of the refrigerator until the doors are aligned. It may take several turns of the leveling screw to raise the refrigerator.
"
6.Make sure the refrigerator is steady. If the refrigerator seems unsteady or rolls forward when the door or drawer is opened adjust the leveling screws. Using a ¹⁄
" hex driver, turn the leveling screw on each side clockwise until the rollers are up
and the leveling feet are 
rmly against the 
or.
NOTE: Having someone push against the top of the refrigerator takes some weight o
the leveling screws. This
makes it easier to turn the screws.
7.Replace the base grille by aligning the ends of the grille with the leveling assemblies on each side and snapping the grille into place.
5