C A R E A N D C L E A N I N G O F Y O U R B E V E R A G E C E N T E R
Condenser
The condenser tubing inside the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over the coils. Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grille on the bottom front of the cabinet.
Cabinet
The painted cabinet can be washed with mild soap and water and thoroughly rinsed with clear water. Never use abrasive scouring cleaners.
Interior
Wash interior compartment with mild soap and water. Do not use an abrasive cleaner, solvent, polish cleaner or undiluted detergent.
Glass Door
Use a glass cleaner or mild soap and water and soft cloth to clean the glass door model. Do not use any abrasive cleaners.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water, a baking soda solution or a mild scour- ing powder.
Light Tube Replacement
WARNING! DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT TUBE REPLACE- MENT. Failure to do so may result in an electrical shock that could severely injure you.
This product uses two, 6 watt light tubes to illumi- nate the interior of the wine cellar. The light tube is a very reliable electrical component, but should it not function properly, please call the dealer you purchased your wine cellar from for a replacement light tube. Use only an original equipment light tube from your dealer or manufacturer.
To replace a light tube, use a
Using a small
Disconnect the two insulated electrical connectors from the cabinet’s electrical cable and discard the old light tube. Reconnect the electrical connector of the new light tube to the cabinet’s electrical cable connectors. Make sure it is secure and fully installed.
Carefully realign the light tube’s electrical terminal back into the rear of the light enclosure channel making sure not to crimp them. Gently insert the light tube along the length of the light enclosure channel. Press the light tube gently into the light enclosure channel. Only a small part of the light tube should project below the ceiling of the wine cellar. DO NOT USE A HAMMER TO FIT THE LIGHT TUBE.
Place the light tube terminal cover plate back in the original position on the light enclosure’s flange. Re- use the original two screws to secure it in place. Plug the wine cellar into the electrical socket. Check to see if the light tubes operate properly. Your light tube’s replacement is complete.
The light tubes are not covered by your warranty. Replacement tubes can be obtained from your service provider or from Marvel Industries.
In the Event of a Power Failure
Most power failures are corrected within two hours and will not affect the unit’s temperature providing you minimize the number of door openings while the power is off. A gradual rise in temperature should not have any adverse effect on your wine if power is out for a longer period. If it is extremely hot, you may want to move your wines to the coolest location you can find until power is restored.
6