Mabe Canada PCR06WATSS Installation Space, SIDE-BY-SIDE Installations, Cutout depth should be 24″

Page 9

Installation Instructions

THE INSTALLATION SPACE

The beverage center and wine chiller can be a free-standing model or it can be built in using the cut-out dimensions below.

 

Locate

 

 

Outlet

 

 

10-1/2" 24"

 

34-1/2"-35"

9" Max.

 

 

1-1/2"

25-1/2"

 

24" Min.

 

 

Product dimensions:

 

 

Height: 34-1/2(876 mm)

 

 

Width: 23-3/4(603 mm)

 

34-1/2"

Depth: 25-1/2(647 mm)

 

 

 

Cut-out dimensions:

Height: 34-1/2–35(876–889 mm)

Width: 24(610 mm) minimum

23-3/4"Depth: 24 (610 mm) minimum

The cutout depth should be 24

The cutout dimensions shown allow for a full door swing and access to the pull-out racks when installed as a built-in in standard 24deep cabinets.

The door should protrude 2-1/4beyond the surrounding

cabinets. For easy reference, the back edge of the pocket handle should protrude a minimum of 5/8beyond the front edge of the countertop.

If installing between frameless cabinets, a 1/2wide filler strip or side panel may be needed on hinge side. The filler strip will act as a spacer between the case and adjacent cabinet door swing. The width of the opening

must include the filler panels. NOTE: The door should protrude 2-1/4beyond the surrounding cabinets.

The beverage center and wine chiller can be installed freestanding.

Additional Specifications

A 120 volt 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall as shown. Electrical must be located on rear wall as shown. NOTE: GFI (ground fault interrupter) is not recommended.

SIDE-BY-SIDE INSTALLATIONS

Increase storage capacity by installing two beverage centers or wine chillers together. Or, for a complete refreshment center, install any two of these units together.

A side-by-side installation requires at least a 47-1/2wide opening. No trim kits required.

Products must operate from separate, properly grounded receptacles.

 

Locate

 

Outlet

 

10-1/2" 14"

10-1/2" 24"

34-1/2"-35"

9"

9"

 

15"

1-1/2"

 

 

 

47-1/2" Min.

9

Image 9
Contents Et d’installation Operating Instructions InstallationInstallation Instructions Manual del Troubleshooting TipsOperating Instructions Care and CleaningTips Consumer Support InstructionsCare and Cleaning TroubleshootingInstallation Instructions Controls and features-Beverage CenterTips Support ConsumerSafety Controls and features-Wine ChillerLoading Tips and Suggestions Troubleshooting Tips Inserting Wine BottlesSafety Controls and features-Beverage Center and Wine ChillerInterior Light and Switch Removing Full Extension DrawersInstructions Operating Care and cleaningProduct Clearances When installed in a cornerRead these instructions completely and carefully Choose the locationSIDE-BY-SIDE Installations Installation SpaceAdditional Specifications Cutout depth should be 24″Parts Supplied Tools RequiredGrounding the Beverage Center and Wine Chiller Staining Wood Drawer FrontsReverse Door Swing SET Temperature Controls Connect PowerLevel Slide Product Into the CutoutNormal operating sounds OperatingFans come on in order to cool the appliance Before you call for service… Safety InstructionsInstallation Instructions Ge.com Care and Cleaning Operating Instructions Safety Instructions Consumer Support Troubleshooting TipsGeneral Electric Company GE Service Protection PlusConsumer Product Ownership Registration Safety Instructions Instructions InstallationCleaning CareWhat Mabe Will Not Cover Mabe Will ReplaceMode d’emploi La section FrançaiseConsommateur Soutien au ’emploi ’entreposez pas ou n’installez pas l’appareil à l’extérieurSoutien au Consommateur Agent de refroidissementBranchement Électrique ’installation Instructions Conseils de dépannageCommandes et caractéristiques-Refroidisseur de boissons Instructions ’installationConsommateur Service ’installation InstructionsChargement des bouteilles de vin Vin rouge Vin blancLumière intérieure et interrupteur Façades de tiroir en boisPour retirer Pour remplacerEntretien et nettoyage ’installation InstructionsChoix de l’emplacement Si installé dans un coinDégagement Requis Pour Ouverture DE Porte Lisez attentivement et soigneusement ces instructionsInstallation Côte À Côte Espace Pour InstallationLa dimension d’encastrement doit être de 61 cm 24 po Caractéristiques supplémentairesPièces Fournies Outils NécessairesTeindre LES Façade EN Bois DES Tiroirs DéballageInversion DU Battant DE Porte Branchement DE L’APPAREIL Mise À NiveauSons normaux de fonctionnement Entretien et nettoyage ’installation InstructionsTemps chaud ou ouvertures Avant d’appeler le service de dépannage…De porte fréquentes La porte est laissée ouverteAppliquez une couche mince de paraffine ou de Conseils de dépannage Instructions d’installation Entretien et Nettoyage Mode d’emploi Consignes de SécuritéOwnership Registration Page Mode d’emploi Ce que GE ne couvre pas Pour la période de GE remplaceraPerte de vin à cause de la détérioration Défectueuse du système scellé de refroidissementProlongation de garantie Soutien au consommateur Service de réparations800.361.3400 Visitez notre site Web ou appelez-nous auLa sección en Español Problemas SolucionarConsejos para la solución Soporte al consumidorRefrigerantes Antes de desechar su antiguo refrigeradorNo almacene o instale este aparato en el exterior Guarde Estas Instrucciones Limpieza Operación Controles y funciones Centro de bebidasControl de temperatura Estantes de cristalInserción de botellas de vino Controles y funciones Refrigerador de vinoAlmacenar ServirQuitar los cajones de extensión completa Cuidado y limpiezaLuz interior e interruptor Para quitar los cajonesCuidado y limpieza Lea estas instrucciones en su totalidad y con atención Tolerancias DEL ProductoCuando se instale en una esquina Elija la ubicaciónInstalaciones Conjuntas EL Espacio DE InstalaciónUna instalación conjunta requiere una apertura de al La profundidad de sección debe ser de 61 cm 24″Partes Suministradas Herramientas NecesariasQuitar EL Embalaje Destornillador Philips número Llave inglesaInvertir EL Sentido DE Apertura DE LA Puerta Conectar LA Alimentación NivelarDeslizar EL Producto Hacia EL Hueco Definir Controles DE TemperaturaWhoosh Sonidos de funcionamiento normalesCuidado y Antes de llamar para solicitar servicio técnico…Se crea humedad en Notas Notas Notas Por el período de GE reemplazará Garantía del centro de bebidas o refrigerador de vinoLo que GE no cubrirá Partes defectuosasLo que Mabe no cubrirá Por el período de Mabe reemplazaráEn Canadá geappliances.ca Soporte al consumidorConsumer Support Canada, callU.S. ge.com

PCR06WATSS, PCR06BATSS specifications

Mabe Canada, renowned for its commitment to quality and innovation in home appliances, presents two of its standout refrigerator models: the PCR06BATSS and the PCR06WATSS. These units epitomize modern design, energy efficiency, and functionality, catering to the diverse needs of today’s households.

Both models feature a sleek and stylish appearance that blends seamlessly with any kitchen decor. The stainless steel finish of the PCR06BATSS adds a touch of sophistication, while the classic white of the PCR06WATSS provides a timeless and clean look. Their compact sizes make them perfect for smaller kitchens, apartments, or as secondary refrigerators in larger homes.

One of the main features shared by both the PCR06BATSS and PCR06WATSS is their spacious interior design. Equipped with adjustable shelves, these refrigerators offer flexible storage solutions that can easily accommodate various sizes and shapes of food items. The well-designed layout ensures that every inch of space is utilized efficiently, making it effortless to organize groceries and ingredients.

These models are powered by advanced cooling technologies that prioritize freshness. With their multi-air flow systems, both refrigerators circulate cold air evenly throughout the compartments, eliminating warm spots and maintaining optimum temperatures. This feature is essential for preserving the freshness of fruits, vegetables, and leftovers.

Additionally, Mabe has incorporated energy-efficient technologies in both models, which significantly reduce power consumption without compromising performance. This not only helps to lower electricity bills but also supports environmentally conscious practices, making them an attractive choice for eco-minded consumers.

The user-friendly interface is another important characteristic of the PCR06BATSS and PCR06WATSS. With easy-to-use controls and clear temperature settings, adjusting the cooling requirements becomes a breeze. Moreover, the interior LED lighting enhances visibility, allowing users to easily find items even in low light conditions.

In terms of capacity, both models provide ample storage without taking up extensive kitchen space. They are perfect for storing essentials for small families or individuals, making meal prep and storage more convenient.

In summary, the Mabe Canada PCR06BATSS and PCR06WATSS refrigerators offer a blend of style, efficiency, and functionality. With their innovative features, energy-saving technologies, and thoughtfully designed interiors, these models stand out as exceptional choices for those seeking reliable and aesthetically pleasing refrigeration solutions in their homes.