Angle Type Pan Slides

SECTION 2-INSTALLATION

b.Steel Rod Type Pan Slide Racks (Refer to Figure 2-10)

Steel rod type pan slide racks are also available. They are designed to accommodate 18” x 26” sheet pans as follows:

●Bottom Support Pan Slide Rack on 2” centers

●Lip Support Pan Slide Rack on 1-1/2” centers

Uprights for mounting the steel rod type pan slide racks are factory installed.

Figure 2-8

The appropriate mounting uprights are already installed, when ordered with your cabinet from the factory. Pan slides cannot be attached to the standard shelf pilaster. Pan slide uprights have 1/2” square holes on 1” centers.

To install an individual slide, locate the appropriate square holes at the desired height. A complete section of slides should be installed by starting at the bottom. Insert tabs of the slide into the uprights and apply pressure in a downward direction until the tab fully engages the upright (refer to Figure 2-9).

Figure 2-9

Installing Stainless Steel Angle Type Pan Slides

Figure 2-10

Steel Rod Type Slides

NOTE: Either pan rack can be used on any of one, two or three section refrigerators.

I.Location of Serial Number/Data Plate

The serial data plate is mounted on the upper left interior wall (see Figure 1-2).

J. Electric Supply

The wiring should be done by a qualified electrician in accordance with local electrical codes. A separate ground wire must be supplied for all installations. A properly wired refrigerator or freezer will assure proper operation. Electrical supply requirements are on the cabinet serial/data plate. It is recommended that a direct, properly protected line of the proper size wire be installed from the main supply to your refrigerator or