WhisperKool EXTREME SERIES, PT-EXPL, 8000ti, 4000 manual System Operation Standard & Remote

Page 26

SYSTEM OPERATION: STANDARD & REMOTE

Initial Start-Up

When power is applied to the unit, the control will briefly display all symbols, and the Compressor sym- bol will be displayed (if unit is calling for cooling). There may be a brief delay prior to the evaporator and condenser fans turning on, as the fans will not turn on until the sensors reach their perspective start tem- peratures (below 70°F for the evaporator and above 80°F for the condenser). When the condenser fan is activated the “AUX” symbol will turn off, and when the evaporator fan is activated the “FAN” symbol will turn on. The temperature control feature for the evapora- tor fan is a feature applicable to Whisperkool Advance Product Safety Technology (APST), which ensures that in the possible event of a cooling deficiency, the heat from the indoor fan will not raise the heat of the wine cellar, which could otherwise have an adverse effect on the wine aging process. After the indoor coil reaches a temperature below 70°F, the indoor fan symbol will be displayed and the fan will turn on. Note: For remote system condenser fan cycles with the compressor, the “Aux” symbol does not apply.

Normal System Cycle

After the bottle probe has reached the set point (all units are shipped with the set point of 55°F and a dif- ferential of 1°F), the compressor and the condenser fan will turn off, but the indoor fan will continue to run for about 5 minutes, which is a feature of the WhisperKOOL Humidity Management (WHM) system. The WHM is an adjustable feature which allows the customer the convenience of managing the humid- ity enhancement of their wine cellar. The WHM is one of the many Customer Preference Selection features which allow the customer the ability to fine tune the controls.

Anti Short Cycle

The Anti Short Cycle ensures that the unit will remain off for a period of 5 minutes after the unit has reached the set point to allow the pressure in the refrigeration system to equalize prior to starting the compressor.

Defrost Cycle

The Defrost Cycle is a precautionary measure, as icing or frosting of the coil does not occur during normal operation. The system will go through a defrost cycle every 4 hours. During the defrost cycle, the indoor fan will provide air flow across the indoor coil, which will evaporate any frost accumulation.

Low Ambient Conditions

If the unit is installed in a Through-The-Wall applica- tion (which will allow the condenser to be exposed to low ambient temperatures), the condenser fan may cycle on and off. The purpose of the fan cycling is to maintain the system high side pressure, which will ensure an adequate refrigeration process. The fan cy- cling process is accomplished by way of a temperature probe attached to the condenser coil.

Note: Remote control systems do not use condenser fan cycling.

Bottle Probe Failure Protection

In the event that a bottle probe should fail, the APST (Advance Product Safety Technology) will automati- cally transition the Refrigeration Compressor cycles to a pre-determined time series (based on detailed laboratory testing), which will ensure that the product is kept within the safe range.

Remote Control Panel (optional)

The control panel can be installed or mounted sepa- rately from the cooling unit itself (remotely), using the supplied cable. This option provides unique flexibility for installing the Extreme Series cooling unit in your wine cellar. The remote option must be specified when the unit is ordered.

Note: Remote Control is generally standard with a “Ducted Unit”

Ducting and Ventilation Options

The ventilation system is ideal for ducting. The option- al collars fit standard ventilation ducting allowing the installer to vent air to and from the unit for optimum performance (please see specifications for details).

Page 26

PT-EXPL 072010

Image 26
Contents Platinum 8000ti PT-EXPL Table of Contents Whisperkool Series Quick Reference Guide ControllerController Quick Reference Guide FAN Speed ReferenceIntroduction Model 4000 8000 8000tiCheck the Accessory Kits for the following contents Customer Warranty RegistrationReview the Packing Slip to Verify Contents Receiving & Inspecting the UnitInsulation Preparing the Wine CellarWall & Ceiling Framing Vapor BarrierDoor and Door Seal Mounting the UnitUnobstructed Airflow Ventilation Ambient Temperature FactorHow to Build a Wine Cellar Instructional Video Exhaust FanSizing the Unit to the Room Cutting the Hole for the WhisperKOOL UnitPT-EXPL Electrical Needs InstallationTest the Unit Prior to Installation Electrical OutletTHROUGH-THE-WALL Installation without ductwork Mounting Flange PiecesDo not Placement of UnitLocation of Supply and Return Grilles Condensation Drain Line Tube Installation Options Exterior Grille InstallationWarm Air to/from Wine Cellar Ducted InstallationCold Air to/from Wine Cellar Ducted Installation Attic Mounted System Standard Ducted InstallationDual Outlet Duct Condenser Exhaust Cold Air Return Air Intake Wine CellarWine Cellar SideCellar Outside through the WallWine Cellar Adjacent Room Return Air-Cellar SideRemote Controller Installation and Configuration Connection wire in Side Mount configuration Liquid Measuring Thermostat System To Use the thermostatVariable Speed Control Only on the 8000tiSystem Operation Standard & Remote Control Panel Features and Operation Button Normal FunctionsCpsm Alarm Codes Remove the filter covering the coil Maintenance ScheduleRemove grille/ducting on both ends of unit Wash with warm waterUnit leaks water Possible Cause Solution Unit does not run/power up Possible Cause SolutionCellar Temperature is to Too Cold Possible Cause Solution Compressor short cycles Possible Cause Solution Unit runs but does not cool Possible Cause SolutionPossible Cause Solution Humidity in cellar too low Solution Possible CauseContact WhisperKOOL Customer Service Technical AssistanceInstallation Terms and Conditions WhisperKOOL Extreme Cooling SystemPage WhisperKOOL 1738 E. Alpine Ave Stockton, CA Page WhisperKOOL

4000, 8000ti, 8000, EXTREME SERIES, PT-EXPL specifications

WhisperKool PT-EXPL Extreme Series represents the pinnacle of wine cellar cooling technology, designed specifically for serious wine collectors and enthusiasts. The series includes four exceptional models: PT-EXPL, 8000, 8000ti, and 4000. Each model is engineered to provide optimal cooling performance, ensuring that your wine is stored at the perfect temperature and humidity for preservation.

The PT-EXPL model is a standout with its advanced cooling technology. This unit features a self-contained design, making installation simple and efficient. It is capable of cooling wine cellars up to 1,200 cubic feet. The PT-EXPL is equipped with a digital thermostat, which allows users to set and maintain precise temperature levels, ensuring that wine is stored under ideal conditions. Additionally, its energy-efficient operation helps minimize utility costs while maximizing cooling performance.

The 8000 and 8000ti models provide even greater capabilities, catering to wine collectors with more extensive collections. The 8000 model is designed for cellars up to 1,500 cubic feet, while the 8000ti can handle spaces up to 2,000 cubic feet. Both models incorporate WhisperKool's patented airflow technology, which optimizes the circulation of cool air within the cellar, preventing hot spots that could adversely affect wine quality. The advanced electronic controls on these units feature multiple settings for temperature and humidity, giving wine enthusiasts even more control over the storage environment.

The 4000 model is engineered for smaller, yet equally significant wine collections, accommodating spaces up to 500 cubic feet. It combines high efficiency with sleek design, making it an ideal choice for both residential and commercial applications. Like its larger counterparts, the 4000 features reliable temperature and humidity control, ensuring that wine is kept in the best possible conditions.

All models in the WhisperKool Extreme Series come equipped with efficient compressors and sound-dampening technology, resulting in quiet operation that won't disturb the ambiance of your wine cellar. With a focus on durability, these units also feature insulated housing and robust construction to withstand the rigors of varied environments.

In summary, the WhisperKool PT-EXPL Extreme Series, including the 8000, 8000ti, and 4000 models, is designed for wine aficionados who prioritize optimal storage conditions. With advanced features, energy efficiency, and reliability, these systems are the perfect choice for preserving the integrity of your wine collection.