WhisperKool 8000ti, PT-EXPL, EXTREME SERIES, 4000 manual Cpsm

Page 28

Energy

1.

The ER feature can be used to save energy and aids in extending the life of the system.

Reduc-

2.

The ER button is located at the top L/H side of the control. The ER feature is activated by press-

tion

ing the ER button one time, and the ER logo will appear on the digital display.

(ER)

3.

The purpose of the ER feature is to reduce energy cost, by shifting the Set Point up by 4 degrees,

 

which will allow the cooling system to run for shorter periods of time, resulting in a reduction in

 

energy cost.

 

4.

The ER feature allows for Energy Savings at any time - During periods of high ambient tempera-

 

tures, vacations or business travel.

 

5.

To deactivate the ER feature, press the ER button one time, and the ER logo will turn off.

 

6.

The ER feature can be conveniently adjusted to the customer’s specific needs, by accessing the

 

“Customer Preference Select Mode” (CPSM). See Customer Preference Select Mode Instructions.

 

Note: This feature is not available on the Remote Key Pad application.

Set

1.

Press the “Set” button once and it will display the Set Point. After approximately 5 seconds, the

Button

display will return to normal operation and display the Bottle Probe temperature.

 

2.

Press and hold the “Set” button for 3-5 seconds until the set point is displayed and the °F symbol

 

starts blinking. Next press the “UP or Down” arrows to change the Set Point. Next press the “Set”

 

button once and the Set Point numbers and the °F on the display will blink to confirm the new Set

 

Point setting.

 

3.

Press and hold the “Set” button during the display of the Hi/Low “Temperature Data History”

 

(hold button unit “rst” blinks on display), and it will erase the past recorded data file and start re-

 

cording, from the current time and temperature.

 

4.

Press the “Set” and the “Down Arrow” buttons simultaneously, for 3-5 seconds, and you will ac-

 

cess the “Customer Preference Selection Mode” (CPSM). The CPSM allows the customer to “Fine

 

Tune” the Control Operating System to their applicable choice.

CPSM

Press the “Set” and the “Down Arrow” buttons simultaneously, for 3-5 seconds, and you will access

Mode

the “Customer Preference Selection Mode” (CPSM). The CPSM allows the customer to “Fine Tune”

 

the Control Operating System to their applicable choice.

 

The following CPSM options are available for adjustment:

Fon – Humidity Management Enhancement: This parameter is normally set at 5, which should provide adequate relative humidity for the cellar.

•An increase in this parameter will increase the Humidity Enhancement (%RH), and a decrease in the parameter will decrease Humidity Enhancement (%RH).

•Adjustments should be made in increments of 5, with a maximum of 15, and a minimum of 0.

•After any adjustment to Humidity Enhancement, you should wait a minimum of three days before making any additional adjustments. This will allow the cellar sufficient time to acclimate to the new setting.

Fof - Humidity Management Enhancement: This parameter is normally set at 1. This parameter should not be adjusted, as it simply provides an OFF cycle time for the fan, during the compressor OFF cycle. However, the parameter is located within the CPSM as a convenience to the customer, should it need to be adjusted.

Page 28

PT-EXPL 072010

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Platinum 8000ti PT-EXPL Table of Contents Whisperkool Series Quick Reference Guide ControllerController Quick Reference Guide FAN Speed ReferenceIntroduction Model 4000 8000 8000tiCustomer Warranty Registration Review the Packing Slip to Verify ContentsCheck the Accessory Kits for the following contents Receiving & Inspecting the UnitPreparing the Wine Cellar Wall & Ceiling FramingInsulation Vapor BarrierUnobstructed Airflow Mounting the UnitDoor and Door Seal Ambient Temperature Factor How to Build a Wine Cellar Instructional VideoVentilation Exhaust FanSizing the Unit to the Room Cutting the Hole for the WhisperKOOL UnitPT-EXPL Installation Test the Unit Prior to InstallationElectrical Needs Electrical OutletTHROUGH-THE-WALL Installation without ductwork Mounting Flange PiecesLocation of Supply and Return Grilles Placement of UnitDo not Condensation Drain Line Tube Installation Options Exterior Grille InstallationCold Air to/from Wine Cellar Ducted InstallationWarm Air to/from Wine Cellar Ducted Installation Standard Ducted Installation Dual Outlet DuctAttic Mounted System Condenser Exhaust Cold Air Return Air Intake Wine CellarOutside through the Wall Wine Cellar Adjacent RoomWine Cellar SideCellar Return Air-Cellar SideRemote Controller Installation and Configuration Connection wire in Side Mount configuration Liquid Measuring Thermostat System To Use the thermostatVariable Speed Control Only on the 8000tiSystem Operation Standard & Remote Control Panel Features and Operation Button Normal FunctionsCpsm Alarm Codes Maintenance Schedule Remove grille/ducting on both ends of unitRemove the filter covering the coil Wash with warm waterCellar Temperature is to Too Cold Possible Cause Solution Unit does not run/power up Possible Cause SolutionUnit leaks water Possible Cause Solution Unit runs but does not cool Possible Cause Solution Possible Cause SolutionCompressor short cycles Possible Cause Solution Humidity in cellar too low Solution Possible CauseContact WhisperKOOL Customer Service Technical AssistanceInstallation Terms and Conditions WhisperKOOL Extreme Cooling SystemPage WhisperKOOL 1738 E. Alpine Ave Stockton, CA Page WhisperKOOL

4000, 8000ti, 8000, EXTREME SERIES, PT-EXPL specifications

WhisperKool PT-EXPL Extreme Series represents the pinnacle of wine cellar cooling technology, designed specifically for serious wine collectors and enthusiasts. The series includes four exceptional models: PT-EXPL, 8000, 8000ti, and 4000. Each model is engineered to provide optimal cooling performance, ensuring that your wine is stored at the perfect temperature and humidity for preservation.

The PT-EXPL model is a standout with its advanced cooling technology. This unit features a self-contained design, making installation simple and efficient. It is capable of cooling wine cellars up to 1,200 cubic feet. The PT-EXPL is equipped with a digital thermostat, which allows users to set and maintain precise temperature levels, ensuring that wine is stored under ideal conditions. Additionally, its energy-efficient operation helps minimize utility costs while maximizing cooling performance.

The 8000 and 8000ti models provide even greater capabilities, catering to wine collectors with more extensive collections. The 8000 model is designed for cellars up to 1,500 cubic feet, while the 8000ti can handle spaces up to 2,000 cubic feet. Both models incorporate WhisperKool's patented airflow technology, which optimizes the circulation of cool air within the cellar, preventing hot spots that could adversely affect wine quality. The advanced electronic controls on these units feature multiple settings for temperature and humidity, giving wine enthusiasts even more control over the storage environment.

The 4000 model is engineered for smaller, yet equally significant wine collections, accommodating spaces up to 500 cubic feet. It combines high efficiency with sleek design, making it an ideal choice for both residential and commercial applications. Like its larger counterparts, the 4000 features reliable temperature and humidity control, ensuring that wine is kept in the best possible conditions.

All models in the WhisperKool Extreme Series come equipped with efficient compressors and sound-dampening technology, resulting in quiet operation that won't disturb the ambiance of your wine cellar. With a focus on durability, these units also feature insulated housing and robust construction to withstand the rigors of varied environments.

In summary, the WhisperKool PT-EXPL Extreme Series, including the 8000, 8000ti, and 4000 models, is designed for wine aficionados who prioritize optimal storage conditions. With advanced features, energy efficiency, and reliability, these systems are the perfect choice for preserving the integrity of your wine collection.
Top Page Image Contents