U-Line 2175RC Remove door, Remove hole plugs, Remove existing top hinge, Reinstall Hole Plugs

Page 19

To reverse the door:
1	3
1
2

Remove door:

1.Hold door to keep it from falling.

2.Remove hinge screw pin (1) from top hinge using a Phillips screwdriver.

3.Remove door by tilting forward and lifting door off bottom hinge closer inserts.

4.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

Remove hole plugs.

Remove plastic screw plugs (three each, top and bottom) (3) from new hinge location. Save for reinstallation later.

Remove existing top hinge.

Remove existing top hinge (three screws) (2).

4

4

Reinstall hinge to bottom opposite.

1.Install the hinge just removed from the top to the BOTTOM opposite side of the cabinet (three screws) (2).

2.Remove the two door closer inserts (4) from the existing bottom hinge.

3.Install door closer inserts as shown on the new bottom hinge

(4).

Remove existing bottom hinge.

Remove the existing bottom hinge (three screws) (2).

Reinstall hinge to top opposite.

Install the hinge just removed from the bottom to the TOP opposite side of the cabinet (three screws) (2).

Reinstall Hole Plugs.

Install plastic screw plugs (three each, top and bottom) (3) into holes where hinge hardware was removed.

1

NOTCH 5

Prepare door for reinstallation.

1.Remove plastic hole plug from top of door handle and reinstall on opposite side.

2.With bottom of door facing up, remove pivot plate (5) (two screws).

3.Flip over and install pivot plate on opposite side of door. Ensure notch in plate faces center.

Install Door.

1.Hold door upright and tilted forward.

2.Lift door on to bottom hinge closer inserts.

3.Tilt door forward into position.

4.Hold door to keep it from falling.

5.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

Align and adjust the door:

Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT above.

U-Line Self-Closing Door Alignment and Reversal

17

Image 19

Contents USE and Care Guide Please Record Your Model Information Read and save this Use and Care GuideIntroduction Table of Contents Line Use and Care Guide General Precautions Safety Alert DefinitionsSafety Precautions Beverage Center Features All 2000 Series Models FeatureWine Captain Model and Beverage Center Features Wine Captain Model FeaturesElectronic Control Panel Adjusting Air TemperatureAir Flow Initial StartupTo check the actual product temperature in the unit Checking Product TemperatureInterior Lighting Touch Electronic Control Quick GuideTop Storage Bin DrawersOther Models Food StorageRed Wines Looking Behind the LabelWine Selections Suggestions Line Wine GuideTerminology Description Ideal Wine Storage ConsiderationsWine Stocking Recommendation Wine Rack Removal and InstallationDo not remove the track rails from the cabinet Staining and final finish application Wood Trim FinishingInstalling the grille Lightbulb ReplacementRemoving and Installing Grille MaintenanceRemoving and Installing Door Shelves Removing and Installing Interior ShelvesLine Use and Care Guide Reversing the door Door Alignment and AdjustmentTo align and adjust the door Door ReversabilityPrepare door for reinstallation Reinstall hinge to bottom oppositeReinstall hinge to top opposite Reinstall Hole PlugsDefrosting Exterior CleaningInterior Cleaning CleaningInterval Every Six Months Condensor CleaningStorage, Vacation and Moving Product DisposalTroubleshooting Guide Before Calling for ServiceIf Service is Required Replacement PartsLine Corporation Limited Warranty LINE.COM