75R, 75WC and 75BEV Models
Reversing the Door
(75R Units Only)
All units may be left- or
6.Remove pivot screw from bottom hinge, invert screw and reinstall pivot screw in hinge. See Figure 6.
7.Install bottom hinge on cabinet, opposite side, aligning flat edge of hinge with outer edge of unit. Partially tighten screws. See Figure 8.
Black and White 75R Units
Note: The grille should not yet be installed. If it has been installed, remove it for door reversing. See Page 11.
To reverse the door on Black or White 75R Refrigerator models:
1.Remove top hinge from cabinet (four screws). See Figure 4. Hold door to keep it from falling.
2.Lift the door off the bottom hinge.
Figure 7 |
Figure 8 |
8.Relocate plastic spacer/bushing on bottom of door to the opposite side. See Figure 9. Clean out bushing hole in door bottom if necessary.
3.Remove four plastic plugs in hinge holes, top of cabinet, opposite side. See Figure 5. Be careful not to scratch cabinet.
4.Remove pivot screw from top hinge, invert screw and reinstall pivot screw in top hinge. See Figure 6. Do not install hinge on cabinet at this time.
Bushing
Figure 9
Figure 10 |
| Hinge |
|
Plastic |
| Plastic |
Plug Hole |
| Plug Hole |
| Screw |
|
Right Side |
| Left Side |
Door Swing |
| Door Swing |
Right Side | Invert | Invert |
Hinge | Screw | Hinge |
Figure 6 |
|
|
5.Remove bottom hinge from cabinet (four screws) and screws on opposite side of cabinet. See Figure 7.
9.Place door on lower hinge pin. Align flat edge of top hinge with outer edge of unit and fasten upper hinge to unit (four screws). Partially tighten screws until door is aligned. See Figure 10.
10.Adjust door to assure proper seal. Tighten upper and lower hinge screws securely.
11.Replace four plastic plugs removed in Step 4 into holes on top of unit. Replace screws in holes in bottom of unit on opposite side.
6 | 02/2005 |