Adding a Final Finish Coat to Wood Trim

75R, 75WC and 75BEV Models

CAUTION

To prevent permanent damage to the inner liner of the Beverage Center, the wine rack wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the stain/finish manufacturer’s instructions prior to re-installing the wood trim inside the cabinet of the Beverage Center. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty.

Adding a Final Finish Coat to Wood Trim

(75BEV Beverage Center Units Only)

Staining Wood Trim a Different Color

(75BEV Beverage Center Units Only)

1.	Remove each wine rack by sliding it out and up. See
	Figure 16.
2.	Remove and save screws securing wood trim to the
	racks.
3.	Apply Minwax Water-Based Wood Stain to wood with a
	synthetic foam brush. Stain must penetrate
	approximately 3 minutes. After this period, while stain
	is still wet, take a stain-dampened rag and remove all
	excess stain. Wipe in the direction of the grain with
	medium pressure to achieve the desired stain color.
4.	After 2 hours, repeat Step 3.

1.Remove each wine rack by sliding it out and up. See Figure 16.

2.Remove and save screws securing wood trim to the racks.

3.Lightly scruff sand the wood trim with 280 grit 3M Tri-M-Ite sandpaper.

4.Remove sanding dust with a tack cloth.

Slide Out

and Up

Figure 16

5.	Allow stain to dry for a minimum of 3 hours before
	finishing.
6.	Sand the wood with very fine sandpaper to smooth the
	surface from the staining process.
7.	Remove sanding dust with a tack cloth.
8.	Apply a thin coat of Minwax Polycrylic, following
	container label for directions. Allow to dry 24 hours.
9.	Lightly sand, tack and reapply 2 times, if desired.
10. Allow the final coat to dry for 24 hours.

5.Apply a thin coat of Minwax Polycrylic, following container label for directions. Allow to dry 24 hours.

6.Lightly sand, tack and reapply 2 times, if desired.

7.Allow the final coat to dry for 24 hours.

8.Reinstall wood trim to wine racks using screws removed in Step 2.

9.Reinstall wine racks in unit.

10.Go on to 5 Adjust Door.

11.Reinstall wood trim to wine racks using screws removed in Step 2.

12.Reinstall wine racks in unit.

13.Go on to 5 Adjust Door.

02/2005