U-Line 75R, 75BEV, 75WC manual Initial Start-Up, Glass Shelf Installation, Start-Up Troubleshooting

75R, 75WC and 75BEV Models

4.Place the two hook-hinges (located on the rear bottom side of the grille) onto the front lip of the unit base. Swing the grille up into position, aligning the grille screw hole on the grille to the grille screw hole on the cabinet. See Figure 22.

9 Start-Up for the First Time

Initial Start-Up

.

Grille

Hook-Hinge

Unit Base

Front Lip

Hook-Hinge

Figure 22

5.Insert the screw. Do not overtighten.

6.Reinstall control knob.

Glass Shelf Installation

(75R Refrigerator and 75BEV Beverage Centers Only)

1.Carefully remove the glass shelves from the packaging.

2.Slide the shelves onto lower sets of ribs, making sure the decorative graphics are on the underside of the shelves. While edge strips go toward the rear and silver edge strips (75R Only) go toward the front. See Figure 23.

The unit is shipped with the control preset to a mid-point setting between 4 and 5. Assure that setting was not altered in shipment. No other adjustments should be necessary at this time. For information about Adjusting the Temperature Control, see the User Manual.

Start-Up Troubleshooting

Q: Problem

Unit does not appear to turn on when plugged in.

A: Solution

Make sure outlet has power (circuit breaker has not tripped).

Q: Problem

The light stays on when the door is closed.

A: Solution

Make sure on/off switch is turned OFF. Check to see that light switch actuator bracket is contacting the light switch properly.

IMPORTANT

See the User Manual’s Troubleshooting Guide for more solutions.

Figure 23

www.U-LineService.com 12 02/2005