Grille Installation, Installation Tip | U-Line 75WC, 75R, 75BEV

75R, 75WC and 75BEV Models

7 Level the Unit

8 Install the Unit

Leveling Information

Note: It is recommended that the unit is level.

Installation of the 75R/75WC/75BEV

1. Plug in the power cord.

1.Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (see Figure 19).

Check

Level

Figure 19

2.	Gently push the unit into position. Be careful not to
	entangle the electrical cord.
3.	Re-check the leveling, from front to back and side to
	side. Make any necessary adjustments. The unit’s top
	surface should be approximately 1/8" below the
	countertop.

Grille Installation

1.Locate and remove the grille screw from the cabinet, using a standard blade screwdriver (or a 1/4" nutdriver). See Figure 21.

2.If the unit is not level, adjust the feet on the corners of the unit as necessary (see Figure 20).

Turn Foot to Adjust

Figure 20

3.Check the levelness after each adjustment and repeat the previous steps until the unit is level. Go on to

8 Install the Unit.

Installation Tip

If the room floor is higher than the floor in the cut-out opening, adjust the rear feet to achieve a total unit rear height of 1/8" less than the opening’s rear height. Shorten the unit height in the front by adjusting the front feet. This allows the unit to be gently tipped into the opening. Readjust the front feet to level the unit after it is correctly positioned in the opening.

Grille Screw

Figure 21

2.Remove the control knob by pulling it away from the cabinet.

3.Identify the grille screw hole on the grille itself. It is located toward the top of the middle recessed section of the grille.

02/2005