U-Line 2275ZWCOL manual Door Alignment and Adjustment, Door Reversability, Reversing the door

Page 17

7 Self-Closing Doors

Door Alignment and Adjustment

Align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior.

IMPORTANT

Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to assure that it is firmly in contact with the cabinet. Also make sure the door gasket is not pinched on the hinge side of the door.

The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top.

1/8"

(3.175 mm)

To align and adjust the door:

1.Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the type (up or down) of adjustment needed.

1

2 3

2.Remove the top hinge pivot pin with a Phillips screwdriver and lift door off bottom hinge pin. Be careful not to lose the door closer insert sets.

3.Turn the door upside down and inspect the hinge plate mounting holes. The plate has slotted mounting holes. Loosen but do not remove the two hinge plate screws(1).

4.If door edge opposite the hinges needs to move up, move plate toward outside of door(2). If door edge needs to move down, move plate toward inside of door(3). Repeat until top edge of door is parallel with top of cabinet and tighten screws (1) securely.

4

5.After adjustment is complete, remove the door closers from the bottom hinge, clean thoroughly and apply petroleum jelly to the mating surfaces of the closers. Be sure that pins on closers align with holes in the door and bottom cabinet hinge plates. Mount door and install top hinge pivot pin.

Door Reversability

Location of the unit may make it desirable to mount the door on the opposite side of the cabinet.

Reversing the door

The Hinge hardware will be removed and reinstalled on the opposite side of the cabinet.

The top hinge hardware will be reinstalled on the bottom of the opposite side of the cabinet.

The bottom hinge hardware will be reinstalled on the top of the opposite side of the cabinet.

U-Line Self-Closing Door Alignment and Reversal

15

Image 17
Contents USE and Care Guide Introduction Read and save this Use and Care GuidePlease Record Your Model Information Table of Contents Safety Precautions Safety Alert DefinitionsGeneral Precautions Line Use and Care Guide Wine Captain Dual Zone Additional Features Wine Captain Dual Zone FeaturesDual Zone Product Features For indoor use onlyAir Flow Dual Temperature ZonesInitial Startup Electronic Control PanelInterior Lighting Checking Product TemperatureTo check the actual product temperature in the unit Touch Electronic Control Quick GuideWine Selections Suggestions Looking Behind the LabelLine Wine Guide Red WinesTerminology Description Ideal Wine Storage ConsiderationsDo not remove the track rails from the cabinet Wine Rack Removal and InstallationWine Stocking Recommendation Staining and final finish application Wood Trim FinishingRemoving and Installing Grille Lightbulb ReplacementMaintenance Installing the grilleWine Rack Removal/Installation Line Use and Care Guide To align and adjust the door Door Alignment and AdjustmentDoor Reversability Reversing the doorReinstall hinge to top opposite Reinstall hinge to bottom oppositeReinstall Hole Plugs Prepare door for reinstallationInterior Cleaning Exterior CleaningCleaning DefrostingStorage, Vacation and Moving Condensor CleaningProduct Disposal Interval Every Six MonthsIf Service is Required Before Calling for ServiceReplacement Parts Troubleshooting GuideLine Use and Care Guide Line Corporation Limited Warranty LINE.COM