U-Line 2275ZWCOL Remove door, Remove hole plugs, Remove existing top hinge, Reinstall Hole Plugs

Page 18

To reverse the door:

 

1

3

 

2

 

Remove door:

1.Hold door to keep it from falling.

2.Remove hinge screw pin (1) from top hinge using a Phillips screwdriver.

3.Remove door by tilting forward and lifting door off bottom hinge closer inserts.

4.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

Remove hole plugs.

Remove plastic screw plugs (three each, top and bottom) (3) from new hinge location. Save for reinstallation later.

Remove existing top hinge.

Remove existing top hinge (three screws) (2).

4

4

Reinstall hinge to bottom opposite.

1.Install the hinge just removed from the top to the BOTTOM opposite side of the cabinet (three screws) (2).

2.Remove the two door closer inserts (4) from the existing bottom hinge.

3.Install door closer inserts as shown on the new bottom hinge

(4).

Remove existing bottom hinge.

Remove the existing bottom hinge (three screws) (2).

Reinstall hinge to top opposite.

Install the hinge just removed from the bottom to the TOP opposite side of the cabinet (three screws) (2).

Reinstall Hole Plugs.

Install plastic screw plugs (three each, top and bottom) (3) into holes where hinge hardware was removed.

1

NOTCH 5

Prepare door for reinstallation.

1.Remove plastic hole plug from top of door handle and reinstall on opposite side.

2.With bottom of door facing up, remove pivot plate (5) (two screws).

3.Flip over and install pivot plate on opposite side of door. Ensure notch in plate faces center.

Install Door.

1.Hold door upright and tilted forward.

2.Lift door on to bottom hinge closer inserts.

3.Tilt door forward into position.

4.Hold door to keep it from falling.

5.Reinstall hinge screw pin (1) into top hinge using a Phillips screwdriver.

Align and adjust the door:

Align and adjust the door, see DOOR ALIGNMENT AND ADJUSTMENT above.

16

U-Line Self-Closing Door Alignment and Reversal

Image 18
Contents USE and Care Guide Read and save this Use and Care Guide Please Record Your Model InformationIntroduction Table of Contents Safety Alert Definitions General PrecautionsSafety Precautions Line Use and Care Guide Dual Zone Product Features Wine Captain Dual Zone FeaturesWine Captain Dual Zone Additional Features For indoor use onlyInitial Startup Dual Temperature ZonesAir Flow Electronic Control PanelChecking Product Temperature To check the actual product temperature in the unitInterior Lighting Electronic Control Quick Guide TouchLine Wine Guide Looking Behind the LabelWine Selections Suggestions Red WinesIdeal Wine Storage Considerations Terminology DescriptionWine Rack Removal and Installation Wine Stocking RecommendationDo not remove the track rails from the cabinet Wood Trim Finishing Staining and final finish applicationMaintenance Lightbulb ReplacementRemoving and Installing Grille Installing the grilleWine Rack Removal/Installation Line Use and Care Guide Door Reversability Door Alignment and AdjustmentTo align and adjust the door Reversing the doorReinstall Hole Plugs Reinstall hinge to bottom oppositeReinstall hinge to top opposite Prepare door for reinstallationCleaning Exterior CleaningInterior Cleaning DefrostingProduct Disposal Condensor CleaningStorage, Vacation and Moving Interval Every Six MonthsReplacement Parts Before Calling for ServiceIf Service is Required Troubleshooting GuideLine Use and Care Guide Line Corporation Limited Warranty LINE.COM