U-Line 1115R, 29R, 1175R manual Wine Rack Removal/Installation, Wood Trim Finishing, 1175BEV

Page 23

Wine Rack Removal/Installation

1175BEV

To remove a rack from the cabinet:

1.Grasp the end of the rack, and gently slide it out until it stops.

2.Remove any bottles stored on the rack.

ULIN_0162_A

Figure 51

3.Press the left rack release lever (Figure 51) down, and at the same time, lift the corresponding right rack release lever up, and pull the rack out until it is free of the tracks and the cabinet.

IMPORTANT

Do not remove the track side rails from the cabinet.

To insert a rack in the cabinet:

1.Align the left and right rack channels with the tracks in the cabinet, and ensuring an even track engagement on both sides, gently push the rack into the cabinet until it stops.

2.Before reloading the rack, ensure proper operation of the travel stops in the left and right track rails by pulling the rack out gently until it completely stops.

Wood Trim Finishing

Interior components of your U-Line unit are equipped with a natural wood trim for appearance and durability. Although this wood trim has been coated with a clear sealer at the factory, it is recommended that the trim be stained (if desired), and receive a final finish coating prior to the unit going into full-time service.

WARNING

To prevent permanent damage to the inner liner of your unit, the wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the product manufacturer’s instructions prior to reinstallation. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty.

If staining the trim is desired, it must be done before the application of any type of final finish. Review the following staining/final finish and final finish-only guidelines when staining/ and or sealing the wood to ensure proper adhesion and durability of the finish.

NOTE: Glass in door is tinted. Stain may look darker when door is closed.

Staining and final finish application:

1.Remove all screws securing wood trim to interior components, and remove the trim from the cabinet interior.

NOTE: Your model may contain an electronic display panel in the lowest level trim piece. After removing the trim screws, and gently pulling the trim from its location, a wiring harness connector will become visible. Unplug the connector, and remove the trim from the interior.

IMPORTANT

DO NOT use oil-based stains on wood trim. Vapors from oil-based stains will permanently penetrate the liner and will not dissipate over time.

2.Apply Minwax® Water-Based Wood Stain to wood with a synthetic bristle brush or a foam applicator. Allow stain to penetrate approximately three minutes. Before the stain is dry, take a stain dampened rag and remove any excess stain remaining. Wipe in the direction of the grain with medium pressure to achieve the desired stain color.

3.After two hours, repeat step 2. This will even out the color of the wood.

4.Allow stain to dry for a minimum of three hours before applying the final finish.

5.If desired, sand the wood with very fine sandpaper to smooth the surface after the staining process.

1115R, 1175R, 29R, 1175BEV

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents 29R 1175BEV 1115R1175R Use and Care GuideIntroduction Warranty RegistrationPlease Record Your Model Information Table of Contents Page Safety Precautions Safety Alert DefinitionsGeneral Precautions Origins Beverage Center Model 1175BEV Product FeaturesRight Temperature for Wine Origins Refrigerator Models 1115R, 1175R, 29ROperation Initial StartupInterior Lighting Electronic Control Panel Temperature Display SelectionTemperature Display Checking Product TemperatureNormal Operating Sounds Manual Temperature ControlAdjusting Temperature Product Disposal Wine Stocking RecommendationsOutdoor, Marine and RV Usage Storage, Vacation, MovingSuggestions for Matching Food and Wine Wine RecommendationsWine Guide Wine Selections SuggestionsWhite Wines Guide to Common Styles of WineCommon Tasting Terms Red WinesCleaning and Maintenance General CleaningMaintenance Interval Every Three Months Condenser CleaningModel 29R Model 1115RModels 1175R and 1175BEV LevelingBlack Model 1115R Door Alignment Check and AdjustmentDoor Reversal Invert Black or White Model 1175R To reverse the door, perform the following ULIN0122A Door Shelf Removal/Insertion 1115R, 1175R and 1175BEV Glass Shelf Removal/InstallationLight Bulb Replacement Do not remove the track side rails from the cabinet Wine Rack Removal/InstallationWood Trim Finishing 1175BEVService Before Calling for ServiceIf Service is Required Replacement PartsTroubleshooting What to check when problems occur Troubleshooting GuideTroubleshooting Models with an electronic display Task Touch Display Comment Electronic Control Quick GuidePage Page Page Line Corporation Limited Warranty For General Inquiries For Service and Parts Assistance

1115R, 1175R, 1175BEV, 29R specifications

U-Line has established itself as a prominent brand in the realm of premium refrigeration solutions, and its model lineup, including the 29R, 1175BEV, 1175R, and 1115R, exemplifies this commitment to excellence. Each of these models offers unique features designed to enhance the user experience, address diverse needs, and complement various home designs.

The U-Line 29R is a standout model known for its versatile ice-making capabilities. With a production rate of up to 28 pounds of clear ice daily, this unit ensures a steady supply for parties, gatherings, or everyday use. One of its primary features includes a self-closing door mechanism, which enhances efficiency by maintaining optimal temperatures. Additionally, the 29R is available in various finishes, allowing consumers to choose a design that seamlessly integrates with their existing appliances.

The U-Line 1175BEV, a premier beverage center, focuses on providing perfect chilling conditions for beverages. This model features dual-zone temperature control, allowing users to maintain different temperatures for various types of beverages, such as wines, beers, and sodas. With a capacity to hold several bottles and cans, the 1175BEV also incorporates an innovative glass door with Low-E coating, which minimizes UV exposure and temperature fluctuations, enhancing the preservation of the beverages inside.

For those seeking an undercounter refrigerator, the U-Line 1175R offers a spacious interior designed to fit a wide range of food and drink items. This model boasts a built-in ice maker, ensuring that users have quick access to ice without the need for additional appliances. Its quiet operation and energy-efficient design make it an ideal choice for modern kitchens, while adjustable shelving provides flexibility to accommodate diverse storage needs.

Completing the lineup is the U-Line 1115R, which is engineered for compact spaces without compromising functionality. This refrigerator features advanced cooling technology that maintains consistent temperatures and humidity levels, which is crucial for preserving the freshness of ingredients. The 1115R is also designed with a sleek, minimalist aesthetic in mind, making it suitable for any style of decor.

In summary, the U-Line models 29R, 1175BEV, 1175R, and 1115R represent the pinnacle of modern refrigeration technology. Each unit is meticulously designed with user-friendly features, customizable options, and energy-efficient operations, catering to aesthetic preferences and functional requirements alike. Whether it’s for ice production, beverage chilling, or food storage, U-Line’s range of high-quality appliances meets the demands of contemporary living spaces.
Top Page Image Contents