U-Line CLR2160, CLRCO2175 manual Door Alignment Check and Adjustment, 175 mm

ULIN_0047_A

Figure 15

A unit that is not level can cause a reduction in ice rate, uneven sized cubes or water spilling into the storage area, which will cause the ice in the bin to melt prematurely (Figure 15).

When checking the level, remember that floors near drains have a tendency to slope towards the drain.

1

ULIN_0043_A

Figure 16

Use a level to check the levelness of the unit from front to back and from side to side. Level should be placed along top edge and side edge as shown (Figure 16).

1 ULIN_0044_A

Figure 17

6.If the unit is not level, adjust the feet on the corners of the unit as necessary (Figure 17).

7.Check the levelness after each adjustment and repeat the previous steps until the unit is level.

Door Alignment Check and Adjustment

IMPORTANT

When properly aligned:

•The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top.

•The door gasket will be firmly in contact with the perimeter of the cabinet and not pinched on the hinge side of the door.

The following procedure will correct for up to 1/4 in. misalignment:

1/8"

(3.175 mm)

ULIN_0016_A

Figure 18

1.Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet (Figure 18) and note the type (up or down) of adjustment needed.

ULIN_0133_A

Figure 19

2.Remove the top hinge pivot pin with a Phillips screwdriver (Figure 19) and lift door off bottom hinge pin. Be careful not to lose the door closer insert sets.

CLR2160, CLRCO2175 15