Light Bulb Replacement
CLRCO2175
To replace the light bulb in your
2 |
1 |
ULIN_0001_A |
Figure 30
1.Grasp the edges of the light housing lens
(Figure 30, 1) opposite the exposed tab, and gently push the lens towards the tab (Figure 30, 2).
2.Pull the edge of the lens down (Figure 30, 1), and swing it out of the light housing.
IMPORTANT
ALWAYS use a genuine
3.Replace the bulb only with a genuine
4.Replace the lens by first inserting the tab side back into the housing at a slight angle. While gently pushing the lens towards the tab end, push the free end up into the housing, and release when you will hear a snap/click.
7 Prepare Plumbing
CAUTION
Plumbing installation must observe all state and local codes. All water and drain connections MUST BE made by a licensed/qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm.
Drain Connection
IMPORTANT
Drain can NOT be located directly below unit. Unit has a solid base that will not allow unit to drain below itself.
The CLRCO2175 can be installed using a Gravity Drain, a
Follow these guidelines when installing drain lines to prevent water from flowing back into the ice maker storage bin and/or potentially flowing onto the floor, causing water damage:
Gravity Drain
A Gravity Drain may be used if:
•Drain line has at least a
•Drain line does not create traps or created traps are vented (see Figure 31).
Normal |
Proper Drain |
With Trap |
Poor Drainage, Water Will Back Up |
With Trap and Vent |
Proper Drain |
Figure 31
See Figure 32 for a typical Gravity Drain installation.
CLR2160, CLRCO2175 | 19 |