U-Line CLRCO2175, CLR2160 manual Door Reversal

1

2 3

ULIN_0201_A

Figure 20

3.Turn the door upside down and inspect the hinge plate mounting holes.

•Your plate has slotted mounting holes (Figure 20, 1). Loosen but do not remove the two hinge plate screws.

4.If door edge opposite the hinges needs to move up, move plate toward outside of door (Figure 20, 2). If door edge needs to move down, move plate toward inside of door (Figure 20, 3). Repeat until top edge of door is parallel with top of cabinet and tighten screws securely (Figure 20, 1).

1

ULIN_0004_A

Figure 21

5.After adjustment is complete, remove the door closers from the bottom hinge, clean thoroughly and apply petroleum jelly to the mating surfaces of the closers. Be sure that bosses on closers (Figure 21, 1) align with holes in the door and bottom cabinet hinge plates. Mount door and install top hinge pivot pin.

Door Reversal

ULIN_0015_A

Figure 22

Black and white units may be left- or right-hand opening. Stainless steel unit doors cannot be reversed. The doors are easily reversed by moving the hinge hardware to the opposite side. The top hinge hardware will be used on the bottom of the other side and the bottom hinge hardware will be used on the top of the other side (Figure 22).

To reverse the door:

1

2

ULIN_0003_A

Figure 23

1.Remove top hinge screw pin (Figure 23, 1) from door using a Phillips screwdriver. Remove door by tilting forward and lifting off bottom hinge pin.

16 CLR2160, CLRCO2175