U-Line CLR2160, CLRCO2175 manual ULIN0002A

1

ULIN_0002_A

Figure 24

2.Remove plastic screw plugs (three each, top and bottom) (Figure 24, 1) from new hinge location. Do not discard.

3.Remove top hinge (three screws) (Figure 23, 2) and reinstall hinge screw pin (Figure 23, 1).

1

ULIN_0005_A

Figure 25

4.Install the removed top hinge mount on opposite side BOTTOM (Figure 25).

5.Remove the two door closer inserts (Figure 26, 1) from the existing bottom hinge and install as shown on the new bottom hinge (Figure 25, 1).

6.Remove existing bottom hinge (three screws) and remount on opposite side TOP. Remove hinge screw pin.

7.Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side.

ULIN_0006_A

Figure 27

8.With bottom of door facing up, remove pivot plate (two screws), flip over, and remount on opposite side of door (Figure 27). Be sure notch in plate faces center.

9.Holding door upright with top of door tilted forward, place hole of door pivot plate on bottom hinge screw pin/closer inserts (Figure 25, 1).

10.Tilt top of door into position in top hinge and install top hinge screw pin.

11.Install plastic screw plugs removed in Step 2 in old hinge holes (three each, top and bottom).

1

ULIN_0004_A

Figure 26

CLR2160, CLRCO2175 17