A DISPLAY OFF mode is available through the control panel. This mode allows you to control whether the display (Figure 4, 3) will be ON or OFF whenever the door is closed. The icon touch sequence that follows will switch between both modes:
NOTE: These are product temperatures, not air temperatures.
1.Touch and hold the WARMER icon (Figure 4, 2), and within five seconds press the POWER icon (Figure 4, 1) three times.
2.The display will be either visible or dark when the door is closed.
3.To return to the previous mode, repeat Step 1.
Temperature Display Selection
The display can easily be adjusted for either type of temperature display. Press and hold the LIGHT icon (Figure 4, 5) and within five seconds press the COOLER icon (Figure 4, 4) three times to change the display as desired.
Temperature Display
To display actual temperatures:
1.Press and hold the WARMER icon (Figure 4, 2) for approximately five seconds and release when the °F symbol in the display (Figure 4, 3) begins to flash.
2.After approximately 10 seconds, the display will return to the
Checking Product Temperature
ULIN_0093_A
Figure 5
To check the actual product temperature in your unit, insert an accurate thermometer into a plastic (non- breakable) bottle that is partially filled with water. Tighten the bottle cap securely (Figure 5).
Place the bottle in the desired area for 24 hours. Refrain from opening the unit during the testing period. After 24 hours, check the temperature of the water. If required, adjust the temperature control in a small increment (See
ADJUSTING TEMPERATURE).
Factors which affect the internal temperatures of the cabinet include:
•Temperature setting.
•Ambient temperature where installed.
•Number of times and length of time the door is opened and closed.
•Installation in direct sunlight or near a heat source.
Adjusting Temperature
IMPORTANT
Adjust the
1 | 2 | 3 | 4 | 5 |
ULIN_0184a_A
Figure 6
8 | 2175BEVS, 2175BEVOL |