Adjusting network

	Section
Audio Adjustments	03

!If you set a large absolute value for the slope (for a steep slope), continuity of sound between speaker units is degraded, and sounds appear to be separated.

!If you set the slope to 0 dB/oct. (pass), the audio signal bypasses the filter, so the filter does not have an effect.

Phase adjustment

When the cross-over point value for filters on both sides is set to –12 dB/oct., the phase is reversed 180 degrees at the filter cut-off fre- quency. In this case, reversing the phase as- sures improved sound continuity.

2 Push MULTI-CONTROL left or right to

select the speaker unit (filter) to be ad-

justed.

Each time MULTI-CONTROL is pushed left or

right, the speaker unit (filter) is selected in the

following order:

SW-HPF (subwoofer HPF)—SW-LPF (subwoo-

fer LPF)—Low-HPF (low-range speaker HPF)

—Low-LPF (low-range speaker LPF)—

Mid-HPF (middle-range speaker HPF)—

Mid-LPF (middle-range speaker LPF)—

High-HPF (high-range speaker HPF)—

High-LPF (high-range speaker LPF)

3 Push and hold MULTI-CONTROL down

Audio Adjustments

1 2

to mute the selected speaker unit (filter).

# To cancel the muting, push MULTI-CONTROL

up.

1 Use MULTI-CONTROL to select NW 1 in

1Normal phase

2Reverse phase

30 dB

4–3 dB

5–12 dB

6Crossover point

Muting the speaker unit (filter)

You can mute each speaker unit (filter). When a speaker unit (filter) is muted, no sound is outputted from that speaker.

!If you mute the selected speaker unit (fil- ter), MUTE blinks and no adjustments are possible.

!Even if any speaker unit (filter) is muted, you can adjust the parameters for other speaker units (filters).

1Use MULTI-CONTROL to select NW 1 in the audio function menu.

Refer to Introduction of audio adjustments on page 24.

the audio function menu.

Refer to Introduction of audio adjustments on

page 24.