6 Maintenance
Lightbulb Replacement
To replace the lightbulb in your
1.Find the light located at the top of the unit. Grasp the edges of the light housing lens (1) opposite the exposed tab and gently push the lens toward the tab (2).
2.Pull the edge of the lens down (1) and swing it out of the light housing.
For Models without adjustable leveling feet:
IMPORTANT
The unit must be located on a level surface, for proper door and ice maker (if equipped) operation.
Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1).
| 2 | Removing and Installing Interior Shelves |
1 |
| |
|
|
IMPORTANT
ALWAYS use a genuine
1.Replace the lens by first inserting the tab side back into the housing at a slight angle.
2.While gently pushing the lens towards the tab end, push the free end into the housing, and release when you hear a snap.
Leveling
IMPORTANT
Unit must be level, for proper door and ice maker (if
1
For Models
with adjustable leveling feet:
1.Use a level to check the levelness of the unit from front to back and from side to side. Place the level along top edge and side edge as shown (1).
2.If the unit is not level, rotate the adjustable leveling legs to raise or lower each corner of the unit (5) as necessary.
3.Check levelness after each adjustment and repeat the previous steps until the unit is level.
3
1
2
For models equipped with glass shelves having recessed shelf supports, remove the shelves as follows:
1.Pull shelf out about 6" (1), until back of shelf clears the “hump” on the
2.Tilt up
3.Remove shelf from unit by pulling out (3).
Insert the shelves as follows:
1.To move to a different position in the unit, insert shelf at an angle, approximately
2.Continue to slide the shelf into the unit at an angle until it clears the door.
Lower the shelf and push it in completely. Ensure the raised edge strip is toward the rear of the unit and the decorative graphics, if applied, are on the underside of the shelves.
IMPORTANT
• Make sure the shelves are inserted fully into the unit.
The edge strip toward the rear prevents cans and bottles from freezing against the cold evaporator.
10 |