U-Line 1000 manual Adjusting AirTemperature, Interior Lighting, Checking Product Temperature

Page 7

Adjusting AirTemperature

IMPORTANT

•Adjust the set point temperature in single increments, and wait 24 hours for the temperature to stabilize before rechecking.

•Factory recommended set-point is MID setting on dial control.

To adjust the set point temperature:

Adjust the temperature by turning the numbered dial (1) in small increments.

1

2

Interior Lighting

Normal Operation. Opening the door will cause the interior of the cabinet to illuminate.

Some models with glass doors have a LIGHT button (2) on the control panel. Note, on some models this is an On Off switch. With this switch turned on the interior light will remain illuminated with the door closed. Do not leave the light on for more than a four-hour period.

Checking Product Temperature

To check the actual product temperature in the unit.

1.Partially fill a plastic (nonbreakable) bottle with water.

2.Insert an accurate thermometer.

3.Tighten the bottle cap securely.

4.Place the bottle in the desired area for 24 hours.

5.Avoid opening the unit during the testing period.

6.After 24 hours, check the temperature of the water. If required, adjust the temperature control in a small increment (See

ADJUSTING TEMPERATURE).

Causes which affect the internal temperatures of the cabinet include:

•Temperature setting.

•Ambient temperature where installed.

•Installation in direct sunlight or near a heat source.

•The number of door openings and the time the door is open.

•The time the internal light is illuminated. (This mainly affects product on the top rack or shelf.)

•The front grille or condenser are obstructed.

U-Line Product Operation

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents USE and Care Guide Please Record Your Model Information Read and save this Use and Care GuideIntroduction Table of Contents General Precautions Safety Alert Definitions Safety Precautions Beverage Center Features All 1000 Series Models FeatureWine Captain Model and Beverage Center Features Wine Captain Model FeaturesProduct Operation Air FlowInitial Startup Control DialInterior Lighting Adjusting AirTemperatureChecking Product Temperature To check the actual product temperature in the unitRed Wines Looking Behind the LabelWine Selections Suggestions Line Wine GuideTerminology Description Ideal Wine Storage ConsiderationsWine Stocking Recommendation Wine Rack Removal and InstallationDo not remove the track rails from the cabinet Staining and final finish application Wood Trim FinishingMaintenance Lightbulb ReplacementLeveling 15 & 29 Models Removing and Installing Door ShelvesRemoving and Installing Grille Installing the grilleStandard Doors Door Alignment and AdjustmentDoor Reversability Reversing the doorPrepare door for reinstallation Install bottom hingePrepare door for reinstallation For black or white doors Install top hinge, and doorDefrosting Exterior CleaningInterior Cleaning CleaningInterval Every Six Months Condensor CleaningStorage, Vacation and Moving Product DisposalTroubleshooting Guide Before Calling for ServiceIf Service is Required Replacement PartsLine Corporation Limited Warranty LINE.COM
Top Page Image Contents