For models equipped with glass shelves having shelf supports, remove the shelves as follows:
1.Open door completely.
2.Grasp the shelf edge in the center and slide the shelf from the unit.
Insert the shelves as follows:
Reposition the shelf as required, ensure the raised white edge strip is toward the rear of the unit and graphics, if applied, are on the underside of the shelves.
Removing and Installing Door Shelves
1
2
For models equpped with door shelves:
To remove the door shelf:
1.Grasp shelf in center, and lift until the shelf notches (1) clear the pins (2).
2.Carefully pull the shelf away from the door.
To install the door shelf:
1.Holding the shelf in the center, center the shelf in the door at the desired location, slightly above the pins (2).
2.Lower the shelf onto the pins (2).
Removing and Installing Grille
WARNING
Disconnect electric power to the unit before removing the grille.
WARNING
DO NOT touch the condenser fins(4). The condenser fins are SHARP and can be easily damaged.
Removing the grille.
1.Disconnect power to the unit.
2.Remove control knob (6) if equipped.
3.Loosen the two screws (1). Some models may have only one screw in the center.
4.Remove grille (2) and grille cap (if equipped)(3) from unit.
Installing the grille:
1.For 15 and 29 models make sure grille cap (3) is behind grille in slots (2) provided in grille before attaching grille to unit.
2.For 75 models place the
3.Align cabinet and grill holes and secure, but do not overtighten grille screws (1).
4.Install control knob (6) if equipped.
5.Reconnect power to the unit.
15 & 29 Models | |
3 | 1 |
| |
6 | 2 |
75Models
Typical Model Shown
6 1
2 |
5 |
11 |