Smeg STA4645U manual Connecting to the air gap no waste disposal unit, Installation Instructions

EN INSTALLATION INSTRUCTIONS

Connecting to the air gap (no waste disposal unit)

MAKE THE CONNECTION UPLINE FROM THE SIPHON OF THE DRAIN LINE AND AT LEAST 400 mm (15-3/4”) ABOVE THE FLOOR ON WHICH THE DISHWASHER WILL BE INSTALLED.

1.Connect the dishwasher drain hose (ref. A fi g. 5-13) to the air gap (ref. B fi g. 5-13) using the wide spring clamp (ref. C fi g. 5-13); if necessary, cut the end of the dishwasher drain hose (ref. D fi g. 5-13) (do not cut the corrugated section). If the drain hose has been cut, use a 38 to 50 mm (1-1/2 to 2”) screw clamp*.

2.To connect the air gap (ref. B fi g. 5-13) to the “T” union (ref. E fi g. 5-13) of the drain line, use a rubber union* (ref. F fi g. 5-13) with spring or screw clamps* (ref. G fi g. 5-13).

* Available from any plumbing stockist

B
C	G
		F	E
			D
	A	G
			Fig. 5-13

22 Rev 0.0