Smeg ST0904 instruction manual Operating instructions, Using the water softening system

Page 19

User instructions

4. Operating instructions

Once the dishwasher has been correctly installed, prepare for use as follows:

Adjust the water softening system;

Add the regenerating salt;

Add the rinse aid and detergent.

4.1Using the water softening system

The amount of scale contained in the water (water hardness index) can cause whitish staining on the dry dishes, which tend to become dull over time.

The dishwasher is equipped with an automatic softening system which uses a special regenerating salt to reduce the hardness of the water.

The dishwasher is factory set for water hardness level 3 (average hardness 41-60°dF24-31°dH).

When using water of medium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.7 Kg of salt in grains. Some models are equipped with an optical no-salt indicator. In these models, the cap of the salt container contains a green float which descends as the salt concentration in the water drops. When the green float can no longer be seen through the transparent cap, the container must be topped up with regenerating salt. The container is situated at the bottom of the dishwasher. After removing the lower basket, unscrew the salt container cap by turning it anticlockwise and pour in the salt using the funnel supplied with the dishwasher. Before replacing the cap, remove any salt residues from around the opening.

When using the dishwasher for the first time, in addition to the salt it is also necessary to add one litre of water to the container.

Each time the salt container is refilled, make sure that the cap is securely closed. The mixture of water and detergent must never penetrate the salt container, as this would compromise the operation of the regeneration system. In the event of this occurring, the warranty will be invalidated.

Only use regenerating salt specially formulated for domestic dishwashers. If using salt tablets, do not fill the container completely.

54

Image 19
Contents Dishwasher Contents Safety and operating instructions Safety instructionsSafety instructions Aquastop Models Installation and hook-up Installation instructionsWater supply connection Electrical connection and precautionsDrain Connection If the Appliance is Provided with a Plugless Supply Cord When Cleaning and Maintaining the ApplianceFor UK only Fuse replacementUpper panel Description of the controlsWASH-ZONE Button Program Delay ButtonOption Button Option LightProgramme Consumption Washing programs Cancelling the Current ProgramTable for Certification Bodies Extra Programs Changing the ProgramTo Save on ENERGY! … and Protect the Environment Water Hardness Table Adjusting the Water Softening SystemRemoving the Dishes END of CycleOperating instructions Using the water softening systemUsing the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser SettingAdding the Detergent Products General warnings and recommendationsUser instructions Using the baskets User instructions Cutlery Basket Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Cleaning the Filter Unit General Warnings and Recommendations for Correct Maintenance If the dishes are not being cleaned properly, check that Fault Description TroubleshootingWater intake system malfunction Technical Data Min ,2 max ,2 kg